Bedienungsanleitung EK63-EdilKamin Firek 3 (Seite 21 von 24) (Englisch)

21

USER INSTRUCTIONS

Ignition with the combustion chamber cold.

1. Check that the existing ash bed is not too high. If

the ash bed becomes too high there is a danger that

hot embers may fall out of the combustion chamber

when the combustion chamber door is opened to add

wood.

2. Move the lever for regulating the air valve to the

“fully open” position. There will be an intense ﬂ ow

of combustion air to the wood in the combustion

chamber allowing quick and eﬃ cient combustion.

3. Place the wood in the combustion chamber without

packing it excessively. Place an ignition unit among

the logs, and ignite. Never use ignition products such

as petrol, alcohol and the like.

4. At this point, close the door and monitor for a few

minutes. If the ﬁ re should go out, open the door

slowly, place another ignition unit among the logs and

ignite it again.

Adding wood when the combustion chamber is

hot

When is the right time to add wood? When the fuel

has almost ﬁ nished and is in hot embers. Using the

glove, open the hinged door slowly (to avoid the

creation of air vortices which could cause smoke to

leak out). Add the desired quantity of wood into the

combustion chamber, placing it on top of the existing

embers (within the quantity limits indicated in the

technical sheet).

Operation with low initial draught

In order to draw in the air for combustion and to

discharge the smoke, the combustion chamber

needs the draught created by the ﬂ ue.

If the draught is weak, initially light a “start up” ﬁ re

using smaller pieces of ignition material.

Once the correct level of draught has been restored,

you can add the fuel.

As with all appliances, a wood appliance heats up and

cools down during the various operating stages. This

causes normal levels of expansion. This expansion

may cause slight settling noises that cannot be used

as a cause for complaint

as a cause for complaint.

FUEL

The product is designed for burning wood pellets or

logs. Use dry wood logs (max. 20% humidity)

Using damp wood will make the product and ﬂ ue

dirty, risk the release of smoke and provide a lower

heat output.

Each type of wood has diﬀ erent properties that

inﬂ uence the output of the combustion process.

The data given in this manual refers to the wood used

during certiﬁ cation.

Generally speaking, wood has a caloriﬁ c value of

approximately 4.5 kWh/kg. When freshly cut it has a

caloriﬁ c value of approximately 2 kWh/kg.

Generally speaking, we recommend using beech,

elm or other class A1 woods in accordance with UNI

EN ISO 17225-5.

Avoid the prolonged use of woods rich in aromatic

oils (e.g. eucalyptus). This may deteriorate the cast

iron components.

Use the recommended quantities of wood.

Overloading may lead to overheating, causing the

following damage:

•possible buckling of the internal parts;

• possible irreversible alterations in the colour of

the paint on the metal parts, for which neither

Edilkamin nor the retailer can be held responsible.

For reasons of safety and environmental compatibility,

DO NOT burn, among other, plastic, painted wood,

coal or bark. Do not use the product as an incinerator.

The use of these fuels will invalidate the warranty.

First ignition procedure

• Make sure you have read and understood this

manual

• Remove

all ﬂ

ammable materials from the

appliance (manuals, labels, etc.). Make sure

you remove the labels on the glass. They would

irreparably damage the glass if they melted.

To light the ﬁ re in the combustion chamber, always

use smaller pieces of wood. Use larger pieces of

wood to feed the ﬁ re once it has started.

Place the wood on the combustion grille.

On ﬁ rst ignition, there may be a slight smell of paint,

which will disappear in a short time.

Always use the glove to touch any hot

parts. Avoid direct contact with hot parts.

EK63-EdilKamin Firek 3 Seite 21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von EK63-EdilKamin Firek 3

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info