Bedienungsanleitung EK63-EdilKamin Kappa (Seite 11 von 28) (Englisch)

810940

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

THE FLUE:

Further to the general prescriptions for the fumes

duct and ﬂ ue, the ﬂ ue

• must serve solely to exhaust fumes

• must be correctly sized to satisfy the

requirements of fumes exhaust (EN 13384-1)

• should preferably be insulated, in steel with

a circular internal section. If rectangular, the

corners must have a radius of not less than

20 mm, with a ratio of the internal dimensions

of <1.5

• must normally be at least 1.5 metres in vertical

length

• must have a constant cross section

• must be waterproof and thermally insulated to

ensure a good draw

• preferably provide a collection chamber for

unburnt fuel and condensates.

• If pre-existing, must be clean, to prevent the

ﬁ re hazard.

• in general, we recommend ﬁ tting a tube inside

the existing masonry chimney if its diameter is

greater than 150 mm.

INTUBATED SYSTEM

INTUBATED SYSTEM:

Further to the general prescriptions for the fumes

duct and ﬂ ue, the intubated system:

• must operate in negative pressure;

• must be open to inspection

• must observe local regulations.

THE CHIMNEY POT

• must be windproof

• must have an internal cross section equivalent

to that of the ﬂ ue and a fumes outlet at least

double that of the interior of the ﬂ ue

• for dual ﬂ ues (which should be spaced at least

2 m apart) the chimney pot receiving the fumes

from the solid fuel appliance or that from the

higher storey, must be at least 50 cm higher

than the other

• it must extend beyond the back ﬂ ow zone (in

Italy, refer to UNI 10683 point 6.5.8.)

• it must allow for maintenance of the chimney

EXTERNAL AIR INTAKE

In general, we suggest two ways to ensure a

proper ﬂ ow of combustion air.

Indirect air intake

Install an air outlet at ﬂ oor level with an eﬀ ective

surface area (net of the screen or other protections)

of at least 80 cm2 (10 cm in diameter).

To prevent draughts, we recommend installing the

intake behind the stove or behind a radiator.

Installing it in front of the appliance will create

unpleasant draughts.

Direct air intake

Install an air intake of eﬀ ective area ((net of the

mesh or other protective equipment) at least equal

to that of the air intake at the back of the product.

Connect the air intake to the appliance’s air intake

with a tube (which may also be ﬂ exible).

A maximum length of 3 metres is recommended,

with no more than 3 bends depending on the draft

of the ﬂ ue.

The air maybe drawn from an adjacent room only

if:

• the ﬂ ow is taken from permanent and

unobstructed openings communicating with

the outdoors;

• the air pressure in the adjacent room is never

lower than that of the outdoor pressure;

• the adjacent room is not a garage. subject to

ﬁ re hazard, a bathroom or bedroom

• the adjacent room is not a shared room in the

condominium

In Italy, UNI 10683 requires that ventilation is

suﬃ cient even if it is guaranteed that the diﬀ erence

in pressure between the outdoor and indoor

environment is equal to or less than 4 PA (UNI EN

13384-1). The installer who issues the declaration

of conformity is responsible for ensuring these

conditions are met..

INSTALLATION

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

EK63-EdilKamin Kappa Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von EK63-EdilKamin Kappa

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info