Bedienungsanleitung EK63-EdilKamin Spot 100H (Seite 20 von 32) (Englisch)

810943

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

SCREW LOADING (only if the stove is completely

without pellets)

To load the screw, enter the MENU by pressing the

key for 2 seconds; then press the key until

the message “M5 ﬁ rst load” appears on the display.

Press the key to conﬁ rm, and then the key

to activate the function.

This operation must only be carried out when the

stove is oﬀ and completely cold.

Note: during this phase, the smoke extractor fan will

remain on.

STAND-BY FUNCTION

In this mode, the stove will go oﬀ when the temper-

ature of the environment is 0.5°C higher than that

requested, after a set time of 10 minutes (which can

be changed by the TAC during installation).

The message “GO STBY” will appear on the display,

indicating the minutes remaining before switch-oﬀ .

This function is available in both ‘AUTOMATIC’

or ‘MANUAL’ mode and in the case of an external

thermostat.

If the environmental temperature falls to 2°C below

the set threshold, the stove will start up again (set-

ting modiﬁ able by the TAC during installation).

To activate the function, press the key for about

3 seconds; the message “M1 set clock” will appear

on the display; press the key until the message

“M4 stand by” appears on the display, then conﬁ rm

by pressing the key .

Press the key to select “ON”, then conﬁ rm by

pressing the key .

To quit the menu “M4 stand by”, press the key

for about 6 seconds.

SETTING THE DATE AND TIME

Press the key for about 2 second; the message

“M1 set clock” will appear on the display; then conﬁ rm

by pressing the key .

The following data will appear in sequence: Day of

the week, hour, minutes, day, month, year; these

can be changed by pressing the key or the key

. To conﬁ rm, press the key .

To quit the menu “M1 set clock”, press the key

for about 6 seconds.

EXTERNAL THERMOSTAT

This must be connected by the blue wire (optional

code 640560) to the serial port positioned on the

back of the stove; it must have a clean, normally

open contact (e.g. in the case of an environmental

thermostat):

- Open contact = Environmental temperature

reached

- Closed contact = Environmental temperature not

reached

To select ‘E-T’ (external thermostat) mode, press the

key (the LED will light up). Pressing the key

will lower the temperature until the message ‘E-T’

(external thermostat) appears on the display (below

6°).

Note: When the stove is oﬀ , the external thermostat

cannot switch the stove on or oﬀ .

If you want to switch the stove on or oﬀ outside the

set time or outside the ‘E-T’ (external thermostat)

setting, you must always do so using the key .

CHRONO-THERMOSTAT FOR DAILY/WEEKLY

PROGRAMMING

There are 3 types of programming (daily, weekly,

weekend), each of which is independent of the

others and thus many combinations are possible

according to the user's requirements (time program-

ming is in 10 minute steps).

Press the key for 2 seconds; the message “M1

set clock” will appear on the display (and the LED

will go out).

Press the key until the message “M2 set

chrono” appears on the display; conﬁ rm by pressing

the key .

To visualise the 3 programming modes (daily, weekly,

weekend) press the key or the key , and con-

ﬁ rm by pressing the key

INSTRUCTIONS FOR USE

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

EK63-EdilKamin Spot 100H Seite 20

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von EK63-EdilKamin Spot 100H

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info