561013
13
Zoom out
Zoom in
Vorherige Seite
1/36
Nächste Seite
Operating controls and connecting terminals
13
1. SUBWOOFER LEVEL
The subwoofer volume control should be adjusted to match the main speaker volume of your hifi or home
cinema system. As a general rule, subwoofer performance should not dominate the sound. Excessive
bass leads to a smeared soundstage and can result in unpleasant resonances at certain frequencies.
2. LOW-PASS CROSSOVER
Used to adjust the frequency at which the subwoofer crosses over. Signals above this crossover fre-
quency are gradually rolled off so they do not interfere with the main speakers. The adjustment of the
crossover frequency will depend on the size and frequency response of the main loudspeakers.
Loudspeaker configuration Crossover frequency
Home cinema set (5.1 …) with LFE channel 120 - 160 Hz
Hifi/Stereo system with very small loudspeak-
ers
80 - 120 Hz
Stereo system with satellites and subwoofer
(2.1)
80 - 120 Hz
Hifi/Stereo system with medium-sized book-
shelf speakers, smaller floor standing loud-
speakers (compatible with most ELAC loud-
speakers)
50 - 80 Hz
3. POWER
Provided on the rear of the subwoofer, there are three positions available:
AUTO: Normal position. The ELAC subwoofer is switched to standby mode (indicator light LED glows
red).
A sensor controls the inputs. If the appropriate bass signal is present, the power output stage is switched
on. Within tenth of a second, the subwoofer is ready for operation (indicator light LED glows green). The
subwoofer switches into standby mode again after a signal pause of more than 15 minutes (indicator light
LED glows red).
Note: If the automatic turn-on operation only responds to full volume, please increase the bass/LFE level
of your surround receiver and decrease the subwoofer level about the same amount. This way, there will
not be any changes in acoustical bass level and the subwoofer will be turned on automatically at a lower
volume.
ON: The subwoofer is operating continuously (indicator light LED glows green).
OFF: The subwoofer is held in standby mode continuously (indicator light LED glows red).
To switch off the subwoofer completely, please switch the MODE control to OFF. A second later, the
Power switch can be turned off without any noise.
4. LED
ON / Standby LED. Glows green when device is switched on; glows red when device is in standby mode.
5. PHASE
The acoustical phase relative to the input phase may be adjusted by means of the phase control knob.
The range is (in phase) to 180° (out of phase). The optimum adjustment should be determined within
the listening test. While going through the whole range of the phase control adjuster, the adjustment with
the highest bass output at the listening place should be kept.
13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Elac SUB 2025 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info