646322
14
Zoom out
Zoom in
Vorherige Seite
1/46
Nächste Seite
8
7
Installa on
16
Outside sensor moun ng
Air/Flue gas system
Air/Flue gas connec ons
Flue gas connec on (7)
Regula ons for the construc on of
ue gas systems are very di erent
for each country. It should be en-
sured that all na onal regula ons
with regard to ue gas systems are
respected.
Connect the ue gas system to the
ue gas connec on (7) of the boiler,
use uegas systems with seamless
connec ons only. Its not necessary
to make a separate condensate drain
for the ue gas system, as the con-
densate will be drained via the sy-
phon of the boiler.
Please note the following issues:
The diameter of the ue gas system
must be chosen by calcula on ac-
cording to the na onal regula ons
Construct the ue gas system as
short as possible (for maximum
length see planner documenta on)
Horizontal ue sec ons must have
fall of not less than 3° back towards
the boiler.
Air intake connec on (8)
The air intake can be connected in
case of room sealed installa on. The
diameter should be calculated ac-
cording to the na onal regula ons,
together with the ue gas system.
The total resistance of both systems
should never overcome the maxi-
mum permissible resistance of the
fan inside the boiler (see also chap-
ter: Technical data).
Requirements and regula ons
Regula ons for the construc on of
ue gas systems are very di erent
for each country. It should be en-
sured that all na onal regula ons
with regard to ue gas systems are
respected. Pay a en on to the fol-
lowing recommenda
ons when di-
mensioning a ue gas system.
Only approved ue gas material may
be used.
The ue gas system must be
properly calculated to ensure a
safe func oning of the system.
Flue gas system components should
be removable for maintenance pur-
poses. Horizontal ue sec ons must
have fall of not less than 3° back to-
wards the boiler.
This Boiler is cer ed for the ue gas
systems B23(P), C13, C33, C43, C53,
C63 and C83.
Materials
Only materials, which are heat re-
sistant and resistant to ue gases
and aggressive condensate, and CE
approved may be used.
See table on page 17 for speci ca-
on of requirements ue gas compo-
nents/materials
Outside sensor moun ng
If an outside sensor (accessory) is
connected to the boiler, the sensor
should be posi oned as shown on
the drawing.
14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Elco THISION L EVO wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info