Bedienungsanleitung Electric Mobility Rascal 600C (Seite 31 von 42) (Englisch)

632962

Zoom out

Zoom in

Vorherige Seite

1/42

Nächste Seite

Rascal R600 Scooter Owner’s Manual

EMC Part: 19271200 • Rev. 03 • 06/01/2003

1. Remove Seat, Batteries, Dash or Tiller, and Front Section as described previously.

2. With the unit still standing upright on the rear bumper, disconnect both electrical connectors (4

prong and 2 prong) of the Drivetrain Power Harness. Remove both of the Quick Disconnect Pins

used to hold leaf springs into position.

3. Grasp the top center of the frame and the seatpost. Rotate unit out and lift straight up.

Transporting your Scooter

By Car — To transport your disassembled scooter by car, place each of the components into the trunk,

being careful not to scratch or mark any of the finished surfaces. Make sure the batteries are right side

up and on a level spot in your trunk. If you need assistance lifting weights, consider asking Electric

Mobility’s Customer Service Department or your authorized service center about the Power Trunk Lift.

This device will assist you in transporting your scooter by transferring these components in and out of

your trunk with very little effort. (See “Specifications” for more information on weights).

By Airplane — To transport your unit on an airplane, we recommend that you call your airline at least

24 hours in advance to ensure that they are aware of your scooter. Your Rascal batteries are approved

for airline travel. Ask specifically where and with whom you should drop the unit off and where and with

whom you should retrieve it at your destination.

Remember to bring this manual with you as a reference on your trip. Your manual will assist you in

disassembling and re-assembling your unit if required.

Prior to leaving the airport, remember to test the unit out when first getting on it. Direct any questions

to the airline personnel if the unit does not work as it did prior to transportation.

If traveling outside of the United States, you may require a different charger or an adapter for your

present charger. Customer Service or your authorized service center can help you answer these

questions and supply you with the charger or adapter you require.

By Bus, Van or Truck without Disassembly — If transporting your scooter fully assembled in a van,

bus, or truck, secure it to the floor using a four point tie-down system. Make sure that the battery

tiedown straps are secure prior to transportation.

The operator of the scooter should then be seated in an approved seat in the transporting vehicle.

WARNING!

This scooter does not meet Federal Safety Standards for motor vehicle

seating. Do not sit, nor permit anyone else to sit, in the seat of your

scooter during transportation in a motor vehicle as this poses a

significant risk of bodily injury or even death.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Electric Mobility Rascal 600C Seite 31

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info