Bedienungsanleitung Electrolux ea 3120 (Seite 6 von 86) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Schwedisch, Norwegisch, Finnisch)

340838

Zoom out

Zoom in

Vorherige Seite

1/86

Nächste Seite

Figure 5.

conditions of load and installation. If it is found

necessary to change the setting, the knob can be

turned to a higher number to give a lower temperature,

or a lower number to give a higher temperature. The

effect of any adjustment can be checked by means

of a thermometer when the refrigerator has reached

the new temperature after some hours.

“0”, disconnect the refrigerator from the electricity

supply and leave the cabinet door open. After

defrosting the cabinet interior should be wiped out

with a clean, damp cloth.

Figure 4.

6. Ice cubes

Fill the ice tray up to 4/5 with drinking water, and

place the ice tray on the ice-tray shelf. Wipe off

any excess water to prevent the ice tray from

freezing to the surface.

To speed up the making of ice cubes, turn the

thermostat to position 5 for a short while. Remember

to turn the dial to its normal setting when the ice

cubes are frozen.

To remove the cubes from the ice tray, hold it under

running water. The ice cubes can now be taken out

easily

7. Useful suggestion

Do not overfill the appliance. Put warm foods and

drinks in the appliance only when they have cooled

down to room temperature. It is advisable to leave

some space between the products in the cabinet to

ensure efficient and even cooling. If the shelves

are packed too tightly there may be unacceptable

temperature variations.

8. Defrosting, cleaning and

maintenance

This frost-formation is kept back by the FUZZY

LOGIC system built into the appliance.

The first defrosting phase commences 39 hours

after the start and lasts for two hours.

After this, the device operates for 22 hours at a

time, followed by a defrosting period of 2 hours.

The frost will melt and the defrost water will run

through the drain tube from the drip channel into an

evaporating vessel located at the bottom rear of the

refrigerator. (Fig 5) The defrost water will evaporate

automatically into the circulating air and the vessel

will not need emptying.

To switch off the unit, turn the thermostat knob to

9. Changing the lightbulb (If available)

If the lightbulb needs changing, pull out the plug and

proceed as follows:

Press the metal reflector to one side and draw the

lamp covering backwards. Replace the bulb and

push the covering back into place.

A new 10-watt bulb can be obtained at any service

shop.

10. Reversing the door hang

(Fig. 6)

Lay the appliance on its back. Remove the 8 screws

(1). Remove the door, together with the two hinges

(2), from the housing.

Remove the two cover caps (3) from the housing

and place them in the open hinge holes in the housing.

Place the bottom righthand hinge in the top left of

the door and the top righthand hinge in the bottom

left of the door and hang the door on its hinges in the

open cover cap holes in the housing. Secure the

hinges and cover caps with the 8 screws.

Check that the door closes easily and is sealed

properly.

Figure 6

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Electrolux ea 3120 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info