Bedienungsanleitung Electrolux eea 120 (Seite 29 von 172) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Portugiesisch, Spanisch, Polnisch, Türkisch, Schwedisch, Norwegisch, Finnisch)

362297

Zoom out

Zoom in

Vorherige Seite

1/172

Nächste Seite

• Do not use the appliance if the water

tank has not been filled.

• Do not use the appliance without the

drip tray or the drip grating.

Safety during cleaning

• Prior to maintenance or cleaning

ensure that the appliance has been

switched off and that the power plug

has been disconnected.

• Follow the instructions referring to

decalcification.

• Do not immerse the appliance in water.

Safety during repairs

Repairs to electrical appliances may

only be carried out by qualified service

engineers. Improper repairs can give

rise to significant hazards for the user.

If the supply cord is damaged, it must

be replaced by the manufacturer, its

service agent or similarly qualified per-

sons in order to avoid a hazard.

If the appliance is used for purposes

other than those for what it was

intended or is operated wrongly, no lia-

bility for possible damages can be

accepted.

;

This appliance conforms with the fol-

lowing EC Directives:

• Low Voltage Directive 2006/95/EC

• EMC Directive 89/336/EEC with

amendments 92/31/EEC and

93/68/EEC

Prior to using the appliance for

the first time

Please read the safety instructions in

order to prevent danger to yourself

and damage to the appliance.

0 Insert the power plug into the power

outlet.

Prior to preparing an espresso for the

first time you should rinse out the

heating system once by filling the tank.

Proceed exactly as described in the

section “Making an espresso” and

“Frothing milk”, but without placing

any ground coffee in the filter. Place a

container that is as large as possible in

the middle of the drip grating

(figure 1/Q) and under the steam noz-

zle (figure 1/F).

Making an espresso

After having been brewed, the espresso

should be covered with a dense frothy

layer, the so-called crema.

To achieve an aromatic espresso with

crema, fresh, clear water, the correct

size grounds and the water tempera-

ture are important.

1. Adding water (Figure 2)

0 Pull the water tank upwards and out of

the appliance (figure 2).

0 Open the tank lid.

0 Fill the water tank with cold, clear

water only.

Ensure that the water line does not lie

below the MIN (minimum) line or

above the MAX (maximum) line.

0 Close the tank lid.

0 Replace the water tank and press it

downwards so that it is sitting firmly in

the appliance.

You can also lift the tank lid and fold it

to the side. This enables you to fill the

water tank directly when it is in the

appliance, e.g. with a jug.

2. Switching on the appliance

0 Switch the appliance on using the on/

off switch (figure 1/A). The power indi-

cator (figure 1/B, red) will illuminate

and the temperature indicator

(figure 1/C, green) will start to blink.

As soon as the operating temperature

has been attained, the temperature

indicator light will be on. The tempera-

ture indicator may blink again while

the appliance is being used to indicate

that the appliance is re-heating.

822_949_384 EEA120_130_Elux.book Seite 29 Freitag, 28. Dezember 2007 5:42 17

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Electrolux eea 120 Seite 29

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info