Bedienungsanleitung Electrolux ESL 46510 (Seite 19 von 68) (Deutsch, Englisch, Holländisch, Französisch)

451762

Zoom out

Zoom in

Vorherige Seite

1/68

Nächste Seite

or make a hole in the bottom of the appli-

ance.

• Do not fill the rinse aid dispenser with

other products than the rinse aid, (dish-

washer cleaning agent, liquid detergent).

This can cause damage to the appliance.

• Make sure that the spray arms can move

freely before you start a washing pro-

gramme.

• The appliance can release hot steam if

you open the door while a washing pro-

gramme operates. There is a risk of skin

burns.

•Do not remove the dishes from the appli-

ance until the washing programme is

completed.

Care and cleaning

• Before you clean the appliance, deacti-

vate it and disconnect the mains plug

from the mains socket.

• Do not use flammable products or prod-

ucts that can cause corrosion.

• Do not use the appliance without the fil-

ters. Make sure that the installation of the

filters is correct. An incorrect installation

causes unsatisfactory washing results

and damage to the appliance.

• Do not use spray water or steam to clean

the appliance. Risk of electrical shock

and damage to the appliance.

Installation

• Make sure that the appliance is not dam-

aged. Do not install or connect a dam-

aged appliance, contact the supplier.

• Remove all packaging before you install

and use the appliance.

• Only a qualified person must do the elec-

trical connection, the plumbing and the

installation of the appliance. This to pre-

vent the risks of structural damage or in-

jury.

• Make sure that the mains plug is discon-

nected from the mains socket during in-

stallation.

• Do not drill into the sides of the appliance

to prevent damage to hydraulic compo-

nents and electrical components.

• Important!Obey the instructions in the

template supplied with the appliance:

– To install the appliance.

– To assemble the door panel.

– To connect to the water supply and

drain.

• Make sure that the appliance is installed

below and adjacent to safe structures.

Frost precautions

• Do not install the appliance where the

temperature is less than 0 °C.

• The manufacturer is not responsible for

frost damage.

Water connection

• Use new hoses to connect the appliance

to the water supply. Do not use used ho-

ses.

• Do not connect the appliance to new

pipes or pipes not used for a long time.

Let the water flow for some minutes, then

connect the inlet hose.

• Make sure not to squash or cause dam-

age to the water hoses when you install

the appliance.

• Make sure that the water couplings are

tight to prevent a water leakage.

• The first time you use the appliance,

make sure that the hoses do not have

water leaks.

• The water inlet hose has a safety valve

and a double sheath with an inner mains

cable. There is pressure in the water inlet

hose only when the water flows. If there

is a leak in the water inlet hose, the safety

valve interrupts the flow of water.

– Be careful when you connect the water

inlet hose:

– Do not put the water inlet hose or

the safety valve in water.

– If the water inlet hose or the safety

valve are damaged, immediately dis-

connect the mains plug from the

mains socket.

– Contact the service centre to replace

the water inlet hose with safety

valve.

Warning! Dangerous voltage.

electrolux 19

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Electrolux ESL 46510 Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info