8
GB
7. Replacing the decorativ door
panel
(Fig. 10-12.)
Disconnect the mains, and lay the appliance on its
back.
Remove the four screws (1) from the lower hinge of
the door.
Remove the door downwards from the upper hinge
bolt.(2-3)
Remove screws (4) and pull off the frame edge (5).
Slide the decorative panel (6) out of the door frame
and insert the new panel (7), so that the upper edge
of the panel runs exactly parallel to the upper edge of
the frame. A new panel can be inserted more easily
into the upper edge of the frame when the corner is
cut off by approx. 5 x 5mm (8). Put the frame edge (5)
back in place and secure with screws.
Place the door on the upper hinge (9), mounting the
lower hinge into the door, and secure with the four
screws (11).
Figure 10.
Figure 11.
Figure 12.
8. Customer service
Before you call a service engineer, carry out the
following simple tests:
If after checking all the above points, the refrigerator is
still not working satisfactorily, contact your nearest
service engineer. State the problem, model, product-
and serial-number.
(Details of the model, product- and serial number
are to be found on the data label in the top left of
the inside compartment.)
Problem
The appliance does not cool sufficiently
The appliance does not cool at all and
the LED-s are flashing
The appliance does not cool at all and
there is no lighting at all
Possible cause
Too much foods to be cooled was put in.
Door is not shut properly.
Refrigerator not level.
Internal air circulation is restricted.
External air circulation is restricted.
CUC system stopped the operation.
Plug is not connected to the mains socket properly.
There is no voltage in the mains socket.
Solution
Put in less food to be cooled.
Check if the door is shut.
Level refrigerator.
Provide inside cool air circulation.
Provide outside air circulation.
See operating instruction 5. 3.
Check if the connection is proper.
Check if there is voltage. (e.g.
Connect a lamp to the socket)
