Bedienungsanleitung Electronics Line EL-2764 (Seite 1 von 2) (Englisch)

580182

Zoom out

Zoom in

Vorherige Seite

1/2

Nächste Seite

Page 1

Wireless Carbon Monoxide Detector

(Model EL-2764)

Introduction

Electronics Line Ltd.'s Wireless Carbon Monoxide Detector (CO) is an

effective device for detecting the buildup of Carbon Monoxide. Upon

detecting the CO gas, the unit emits an alarm and notifies the control panel.

The main features of your CO gas detector include the following:

 Integrated transmitter designed for use with EL's wireless alarm

systems

 Easy to install

 Monitoring of carbon monoxide in a continuous manner.

 Loud alarm (85 dB) when detecting a buildup of carbon monoxide

 Test button

 Continuous Self-testing function

What You Should Know About Carbon Monoxide

Carbon monoxide, also known as "CO" by the chemical form, is

considered to be a highly dangerous poisonous gas, because it is

colorless, odorless, tasteless and very toxic. In general, biochemistry

phenomena have shown that the presence of CO gas inhibits the blood's

capacity to transport oxygen throughout the body, which can eventually

lead to brain damage.

In any closed space (home, office, recreational vehicle or boat) even a

small accumulation of CO gas can be quite dangerous.

Although many products of combustion can cause discomfort and adverse

health effects, it is CO gas which presents the greatest threat to life.

Carbon monoxide is produced by the incomplete combustion of fuels such

as natural gas, propane, heating oil, kerosene, coal, charcoal, gasoline, or

wood. The incomplete combustion of fuel can occur in any device which

depends on burning for energy or heat such as furnaces, boilers, room

heaters, hot water heaters, stoves, grills, and in any gasoline powered

vehicle or engine (e.g. generator set, lawnmower). Tobacco smoke also

adds CO to the air you breathe.

When properly installed and maintained, your natural gas furnace and hot

water heater do not pollute your air space with CO. Natural gas is known

as a "clean burning" fuel because under correct operating conditions, the

combustion products are water vapor and carbon dioxide (CO

), which is

not toxic. The products of combustion are exhausted from furnaces and

water heaters to the outside by means of a fuel duct or chimney.

Correct operation of any burning equipment requires two key conditions:

(a) An adequate supply of air for complete combustion.

(b) Proper venting of the products of combustion from the furnace

through the chimney, vent or duct to the outside.

Typical carbon monoxide gas problems are summarized here:

(a) Equipment problems, due to defects, poor maintenance,

damaged and cracked heat exchangers

(b) Collapsed or blocked chimneys or flues, dislodged, disconnected

or damaged vents

or circuitous flue runs, improper location of flue exhaust or wind

conditions

(d) Improper installation or operation of equipment, chimney or vents

(e) Air tightness of house envelop/inadequate combustion of air

(f) Inadequate exhaust of space heaters or appliances

(g) Exhaust ventilation/fireplace competing for air supply

Potential sources of carbon monoxide in your home or office include

clogged chimney, wood stove, wood or gas fireplace, automobile and

garage, gas water heater, gas appliance, gas or kerosene heater, gas or

oil furnace and cigarette smoke.

Installing the Detector

Selecting the installation location

Since CO gas moves freely in

the air, the suggested location

is in or as near as possible to

sleeping areas of the home,

30 cm (12 inch) below the

ceiling . For maximum

protection, a CO detector

should be located outside the

primary sleeping areas or on

each level of your home

(see Fig 1 for suggested

locations).

Fig. 1

IMPORTANT:

This device is not suitable for installation in a hazardous location, as

defined by the US National Electrical Code.

Do not place the detector in the following areas:

(a) Where the temperature may drop below 4C (39F) or exceed 38C

(100F).

(b) Near paint thinner fumes

stoves and fireplaces

(d) In exhaust streams from gas engines, vents, flues or chimneys

(e) Do not place in proximity to an automobile exhaust pipe; this will

damage the detector

To install the detector:

1. Remove the mounting bracket from your unit according to Fig. 2.

1 2 3

Fig. 2

2. Hold the Mounting bracket against the wall as a template and mark the

locations for the 2 mounting holes.

3. Using a 5 mm (3/16-inch) drill bit, drill two holes at the marks and

insert wall plugs (Fig 3).

Fig. 3

4. Secure the mounting bracket to the wall.

5. Open the battery cover by pushing down on the battery snaps (Fig. 4).

Fig. 4

6. Insert the batteries (supplied) into the battery compartment. Pay

attention to the correct battery polarity (+) (-) and close the battery

compartment

7. Line up the side slot of the bracket and the detector. Push the detector onto

the mounting bracket until a click is heard (see arrow direction, Fig 3).

8. Pull the detector outwards to make sure that it is securely attached to

the mounting bracket.

Transmitter/Receiver Communication Setup

1. Set the panel to registration mode.

2. Insert the batteries into compartment. The detector enters

registration mode during which a transmission is sent every few

seconds. You can terminate registration mode by pressing the Test

Button. Test mode is automatically terminated after approximately

five minutes.

3. Verify that the detector has been identified by the receiver.

LED & BUZZER Indication

The LED light and the buzzer turn on and/or off to indicate various

situations. There are four different light and buzzer operations:

LED

LED Status

Buzzer

Meaning

Green

(Power)

Flashing On and Off

every 30 seconds

Normal condition

RED

(Alarm)

Flashing

Sequential Alarm

Sound

Alarm

Orange

Flashing On and Off

Sequential Alarm

Internal self test fail

CARBON MONOXIDE DETECTOR

GROUND

FLOOR

BASEMENT

KITCHEN

GARAGE

BEDROOM

BEDROOMBEDROOM

Electronics Line EL-2764 Anleitung

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info