Bedienungsanleitung Electronics Line EL-2764 (Seite 2 von 2) (Englisch)

580182

Zoom out

Zoom in

Vorherige Seite

1/2

Nächste Seite

Page 2

(service)

Sound

- service required

All LED's

Flashing

3 beeps for a period of

3 seconds

Test mode

TEST/HUSH POWER SERVICE ALARM ALARM VENT

SENSOR VENT

Fig. 5

Testing And Resetting Your Detector

A green power light indicates that power is supplied. To test the detector,

press the Test button. The detector will beep intermittently and the three

LEDs will flash. Release the Test button. The beep and the three LEDs will

stop and the green LED remains on or flashes every 60 seconds.

Muting Your Detector

You can partially mute the detector in an event of alarm by pressing the

Test Button. The Red LED will continue to flash and a short beep will be

heard every 16 seconds.

Detector Malfunctioning

A malfunctioning unit is indicated by beep-sounding on and off

sequentially, i.e., beeping for 3 seconds with 3 seconds delay between two

beeps. If this occurs, remove the batteries from the unit for 10 seconds

and then install them again. Should the unit again beep intermittently, DO

NOT use this detector. Send the malfunctioning unit to the manufacturer

for servicing.

Taking Care Of Your Detector

You have to maintain the detector to ensure proper operation:

1. Use a vacuum cleaner to clean the air vents occasionally to keep

them free of dust.

2. Press the Test button on your detector to test its operation once

every week.

Actions to Take When Alarm Sounding

In case of harmful levels of CO gas being detected, your detector will go

into a continuous full alarm. Try to take the following necessary actions

immediately:

(a) If there is anyone experiencing the effects of carbon monoxide

poisoning such as headache, dizziness, nausea or other flu-like

symptoms, call your fire department or emergency service department

right away. You should evacuate all the people in the premises

immediately. Do a head count to check that everybody is present.

(b) Do not re-enter the premises until the problem has been corrected

and the CO gas has been dispersed out and a safe level is reached.

windows and doors. Turn off fuel burning appliances and call a

qualified technician or your utility company to inspect and repair your

problem before restarting appliances.

WARNING: Normally an activation of the detector indicates the presence

of CO gas. However, the CO gas can be extremely fatal, if it is not

detected. The source of the CO gas may come from several possible

situations, please refer to the list of sources of carbon monoxide in page 1.

CAUTION: This detector will only indicate the presence of CO gas at the

sensor. However, you have to be aware that the CO gas may be present in

other areas in the premises.

Actions to Take After The Problem is Corrected

Once the problem of the CO gas presence in the premises has been

corrected, the detector alarm should be off. After waiting for 10 minutes,

push the Test button to test the detector, and by that, being confident that

the detector is working properly again.

Technical Information

The Carbon Monoxide Detector is engineered to be able to provide alarm

sounds based on the UL standards due to various exposure times at

different level of carbon monoxide concentrations.

According to the Underwriters Laboratories Inc. the carbon monoxide

concentrations and exposure time standards for the alarms have been

established and specified below:

A full alarm is activated under the following conditions:

- between 60 and 90 minutes at exposures of 70 ppm

- between 10 and 30 minutes at exposures of 150 ppm

- between 4 and 10 minutes at exposures of 400 ppm

SPECIFICATIONS

Electrical

Battery Type:

2 x CR 123, 3V Lithium Battery

Current Consumption:

20 A standby, 30mA Alarm

Frequency:

433.92 MHz or 868.65 MHz

Supervision Transmission:

15 min. - for 868.65 MHz model

65 min. - for 433.92 MHz model

Signal Volume:

85 dB at a distance of 3 meters (10 feet)

Battery Life:

3 years typical

Physical

Size (L X W X H):

140 X 80 X 49 mm

(5.5 inch x 3.2 inch x 2 inch)

Environmental

Operating Temperature:

4C to 38C (39F to 100F)

Storage Temperature:

-20C to 60C (-4F to 140F)

Based on the requirements of UL 2034 Standard

Specifications are subject to change without prior notice. Should any questions

arise please contact your supplier.

WARNING AND LIMITATION

This detector may not alarm at low carbon monoxide levels. The

Occupational Safety and Health Association (OSHA) has established that

continuous exposure levels of 30 ppm should not be exceeded in an 8

hours period. Individuals with a medical problem may consider more

sensitive detection devices.

The CO gas detector is not suitable as a smoke or fire detector. This

detector is not suitable to install in a hazardous location, as defined in the

National Electrical Code.

This detector will not work without power. EL's Carbon Monoxide Detector

will not work if the batteries are removed for any reason. Additionally,

carbon monoxide must reach the detector for the proper performance of

CO gas detection.

Carbon monoxide detectors may wear out because they contain electronic

parts that fail at any time. Test your detector at least once week (see the

section "TESTING YOUR DETECTOR").

Electronics Line Ltd.Limited Warranty

EL and its subsidiaries and affiliates ("Seller") warrants its products to be free from

defects in materials and workmanship under normal use for 24 months from the date of

production. Because Seller does not install or connect the product and because the

product may be used in conjunction with products not manufactured by the Seller,

Seller can not guarantee the performance of the security system which uses this

product. Sellers' obligation and liability under this warranty is expressly limited to

repairing and replacing, at Sellers option, within a reasonable time after the date of

delivery, any product not meeting the specifications. Seller makes no other warranty,

expressed or implied, and makes no warranty of merchantability or of fitness for any

particular purpose. In no case shall seller be liable for any consequential or incidental

damages for breach of this or any other warranty, expressed or implied, or upon any

other basis of liability whatsoever. Sellers obligation under this warranty shall not

include any transportation charges or costs of installation or any liability for direct,

indirect, or not be compromised or circumvented; that the product will prevent any

persona; injury or property loss by intruder, robbery, fire or otherwise; or that the

product will in all cases provide adequate warning or protection. Buyer understands

that a properly installed and maintained alarm may only reduce the risk of intruder,

robbery or fire without warning, but is not insurance or a guaranty that such will not

occur or that there will be no personal injury or property loss as a result. Consequently

seller shall have no liability for any personal injury, property damage or loss based on a

claim that the product fails to give warning. However, if seller is held liable, whether

directly or indirectly, for any loss or damage arising from under this limited warranty or

otherwise, regardless of cause or origin, sellers maximum liability shall not exceed the

purchase price of the product, which shall be complete and exclusive remedy against

seller. No employee or representative of Seller is authorized to change this warranty in

any way or grant any other warranty.

WARNING: This product should be tested at least once a week.

CAUTION: Risk of explosion if battery is replaced by an incorrect type. Dispose

of used batteries according to local regulations.

Contacting Electronics Line Ltd.

International Headquarters:

Electronics Line Ltd.

14 Hachoma St., 75655

Rishon Le Zion, Israel

Tel: (+972-3) 963-7777

Fax: (+972-3) 961-6584

No part of this document may be reproduced in any form without prior written

permission from the publisher.

(CE is for 868.65 MHz model only)

Electronics Line EL-2764 Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info