Bedienungsanleitung Elica Artica AST (Seite 5 von 7) (Englisch)

471126

Zoom out

Zoom in

Vorherige Seite

1/7

Nächste Seite

INSTRUCTION ON MOUNTING AND USEGB

123 4 5 6 7

21.Slide the bottom section of the chimney down until it

completely covers the suction unit and slots into the

housing provided on top of the hood.

22.Turn the mains power on again at the central electrical

panel and check for correct hood operation.

Carry out the SET-UP of the control panel, if necessary.

To do this consult the Functioning  SET UP paragraph

in the following pages.

Electrical connection

The electrical tension must correspond to the tension noted

on the label placed inside the cooker hood. Connect the

electrical plug, where provided, to the an easily accessible

outlet in conformity with local standards in force.

Where an electrical plug is not provided (for direct connection

to electrical network) place a standards approved bipolar

switch with an aperture distance of not less than 3mm

(accessible) from the contacts.

Description of the hood - Fig. 1

1. Control panel

2.Grease filter

3. Grease filter release handle

4. Halogen lamp

5. Vapour screen

6. Telescopic chimney

7. Air outlet (used for filter version only)

8. Sensor

Operation 

Model with electronic controls

Main Functions

1 - ON-OFF lamp button

2 - Led signal for anti-grease filter saturation (See the relative

cleaning instructions for anti-grease filters).

3 - Led signal for active carbon filter saturation (See the

relative cleaning instructions for active carbon filters).

4 - Led signal for automatic operation

5 - ON-OFF button for automatic operation

6 Functions signal (Led Display).

7 - ON/OFF Knob and suction power selection.

List of Functions

To switch the cooker hood to (ON) depress knob 7

The operation of button 5 is enabled and the wording

Sensor will appear, the cooker hood will set at

Manual Stand-By.

To switch the cooker hood to (OFF) depress knob 7

again; if the cooker hood is set in the automatic

operation mode then depressing knob 7 once will launch

the cooker hood to manual Stand-By depressing the

knob again will switch the cooker hood to (OFF).

Attention! When the cooker hood is switched (OFF) all the

functions are disabled.

To switch on the lamps depress button 1.

To switch off the lamps depress button 1 again.

To increase the suction speed rotate knob 7 clockwise

and set the desired speed (1, 2, 3 or intensive).

Attention

The intensive suction speed is timed for 5 minutes after

which the cooker hood returns to the 2

speed.

The led number (1, 2 or 3) will appear on the Display,

which is equivalent to the suction speed set plus a red

led will also appear when the suction speed is set at

intensive.

The other display leds will turn on alternatively in

proportion to the suction power setting.

To decrease the suction speed rotate the knob

anticlockwise (Intensive, 3, 2, 1, Stand-by)

Filter Saturation Signal

The cooker hood is provided with an electronic device

which signals the necessity to clean and/or replace the

filters (Grease or Active Carbon).

Attention!

The saturation signal device for the active carbon

filter is disabled, the enabling (or disabling) function is

performed in the SET-UP operation (see instructions at

the bottom of the page).

Grease filter saturation signal

The LED signal 2 will turn on.

Active Carbon filter saturation signal

The LED signal 3 will turn on.

Attention! The signal will not appear when the cooker hood

is switched (OFF) or in stand-by mode.

Reset the Filter saturation signal (to be carried out ONLY

after having cleaned and/or replaced the filters):

Set the cooker hood to stand-by depress button 7 until

the sound of the beep and upon the turning off of the

wording sensor.

Automatic Operation

The cooker hood always sets at manual operation,

depressing button 5 the cooker hood sets to automatic

operation: the wording Sensor turns on (from white

to orange); the cooker hood starts up and regulates the

speed only if the sensors, of which the cooker hood is

equipped, detect any variations in the environment

conditions. The led signals for function 6 will turn on in

sequence at a speed that varies the suction speed that

it sets automatically on the basis of the sensors readings.

Depressing button 5 again and rotating knob 7 the cooker

hood returns to manual operation.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Elica Artica AST Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info