Bedienungsanleitung Elica Get Up (Seite 32 von 224) (Alle Sprachen)

784509

Zoom out

Zoom in

Vorherige Seite

1/224

Nächste Seite

directive 2012/19/EC - UK SI 2013 No.3113 on Waste

Electrical and Electronic Equipment (WEEE).

• By ensuring this product is disposed of correctly, you will

help prevent potential negative consequences for the

environment and human health, which could otherwise be

caused by inappropriate waste handling of this product.

• The symbol on the product, or on the documents

accompanying the product, indicates that this appliance may

not be treated as household waste. Instead it should be taken

to the appropriate collection point for the recycling of electrical

and electronic equipment. Disposal must be carried out in

accordance with local environmental regulations for waste

disposal.

• For further detailed information regarding the process,

collection and recycling of this product, please contact the

appropriate department of your local authorities or the local

department for household waste or the shop where you

purchased this product.

Appliance designed, tested and manufactured according to:

• Safety: EN/IEC 60335-1; EN/IEC 60335-2-31, EN/IEC

62233.

• Performance: EN/IEC 61591; ISO 5167-1; ISO 5167-3; ISO

5168; EN/IEC 60704-1; EN/IEC 60704-2-13; EN/IEC 60704-3;

ISO 3741; EN 50564; IEC 62301.

• EMC: EN 55014-1; CISPR 14-1; EN 55014-2; CISPR 14-2;

EN/IEC 61000-3-2; EN/IEC 61000-3-3; ETSI EN 301 489-

1;ETSI EN 301 489-17; ETSI EN 300 328; IEC 62311:2019.

Suggestions for a correct use in order to reduce the

environmental impact: Switch ON the hood at minimum

speed when you start cooking and kept it running for few

minutes after cooking is finished. Increase the speed only in

case of large amount of smoke and vapor and use boost

speed(s) only in extreme situations. Replace the charcoal

filter(s) when necessary to maintain a good odor reduction

efficiency. Clean the grease filter(s) when necessary to

maintain a good grease filter efficiency. Use the maximum

diameter of the ducting system indicated in this manual to

optimize efficiency and minimize noise.

Use

The hood is designed to be used either for exhausting or filter

version.

Extraction version

In this case the fumes are conveyed outside of the building by

means of a special pipe connected with the connection ring

located on top of the hood.

CAUTION!

The exhausting pipe is not supplied and must be purchased

apart.

Diameter of the exhausting pipe must be equal to that of the

connection ring.

CAUTION!

If the hood is supplied with active charcoal filter, then it must

be removed.

Filtration version

The aspirated air will be degreased and deodorised before

being fed back into the room.

In order to use the hood in this version, you have to install a

system of additional filtering based on activated charcoal.

Note: The recycled air in the charcoal filter is sent back to the

kitchen through a duct which conveys air on a side of the

cabinet.

The models with no suction motor only operate in ducting

mode, and must be connected to an external suction device

(not supplied).

The connecting instructions are supplied with the peripheral

suction unit.

Mounting

Before starting to mount the appliance, make sure that no

component is damaged, otherwise contact the dealer and stop

mounting. In addition, read all the instructions below carefully.

• Use an air outlet pipe no longer than 5 metres.

• Limit the number of curves in the duct since each curve

reduces the suction effectiveness equivalent to 1 linear

metre. (E.g.: if two 90° curves are used, the duct should

be no longer than 3 metres).

• Avoid drastic changes of direction.

• Use a duct with 150mm diameter constant for the whole

length.

• Use a duct made of standard complying material.

• In case of failure to observe the instructions above, the

supplier can not be held responsible for capacity or noise

problems and no warranty will be granted.

• Before making the hole, make sure that the inside of the

cabinet, near the hood housing area, does not have the

structure of the cabinet or other particulars which may

cause problems for the proper installation. Make sure

that the overall dimensions of the hood and the hob ae

compatible with the cabinet and therefore the installation

is feasible.

• Before inserting the screws into the cabinet, make sure

that the product is perfectly perpendicular to the worktop.

Panel Assembly

(only for models where the panel is not supplied with the

hood)

CAUTION!

Installation must be carried out only by qualified installers.

FOR THE INSTALLER: Responsibility for installation of the

hood, including verification of the conformity of any fixing kit

supplied with the product, is the sole responsibility of the

installer. Following is a non-exhaustive list of helpful

instructions for the installer:

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Elica Get Up Seite 32

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info