Bedienungsanleitung Elica Horizonte (Seite 8 von 10) (Englisch)

471153

Zoom out

Zoom in

Vorherige Seite

1/10

Nächste Seite

11. Apply the flues support bracket G to the wall adherent to

the ceiling, use the flues support bracket as a perforation

diagram (if present, the small slot on the support must

coincide with the line drawn previously on the wall) and

mark two holes with a pencil. Make the holes (Ø8mm),

and insert 2 dowels.

12. Fix the chimney support bracket to the wall using two

5x45mm screws.

13. Hook the hood onto the bottom bracket.

14. Fix the hood into its final position on the wall

(ABSOLUTELY ESSENTIAL).

15. Connect a pipe (pipe and pipe clamps not provided, to be

purchased separately) for discharge of fumes to the

connection ring located over the suction motor unit.

If the hood is to be used in ducting version, the other end

of the pipe must be connected to a device expelling the

fumes to the outside. If the hood is to be used in filter

version, then fix the deflector F to the chimney support

bracket G and connect the other extremity of the pipe to

the connection ring placed on the deflector F.

16. Connect the electricity.

17. Insert the flue into its housing over the hood to cover the

suction unit completely.

18. Fix them above with 2 screws (18a) to the G flues

support bracket (18b).

Remount the carbon filter frame and the fat/s filter/s and check

the perfect functioning of the hood.

Additional instructions for the montage

Installing the panel

(number and form of the panels can vary on the basis of the

model)

The panel is supplied dismounted.

Hook the panel onto the pins of the hood and fix with the

supplied latch S (the number varies on the basis of the model

- safety-fixing compulsory!).

Rotate the panels to cover the suction area and hook to the

central pin, pressing with decision.

Check that the panel is blocked in position. Fig. 7

Description of the hood

Fig. 1

1. Control panel

2. Grease filter

3. Grease filter release handle

4. Halogen lamp

5. Vapour catcher

6. Telescopic chimney

7. Air outlet (used for filter version only)

8. Panel

Operation

Use the high suction speed in cases of concentrated kitchen

vapours. It is recommended that the cooker hood suction is

switched on for 5 minutes prior to cooking and to leave in

operation during cooking and for another 15 minutes

approximately after terminating cooking.

Control panel

To select the functions of the hood just touch the commands.

Light key ON/OFF

Intensive speed selection key (suction

power) - duration 5 minutes - press again to

return to previous setting.

High-speed selection key (suction power).

Medium-speed selection key (suction power)

- when flashing it indicates the need to wash or

replace the carbon filter. This signal is normally

deactivated. Press keys 1 and 2 at the same

time to activate it. At first only key 1 will flash

and then both keys 1 and 2 to indicate

activation. Repeat the operation to deactivate

the signal. At first keys 1 and 2 will flash and

then only key 1 to indicate deactivation.

Low-speed selection key (suction power) –

when flashing it indicates the need to wash the

fats filter.

Motor key OFF (stand by) – excludes the

electronics – reset wash/replace filters signals.

MOTOR OFF

Press briefly to switch the motor off.

RESET FILTERS SIGNALS

fter having carried out maintenance of the

filters, press the key for 3 seconds. Flashing led

1 (fats filter) or 2 (carbon filter) will stop

flashing.

EXCLUDING THE ELECTRONICS

Press the key for 3 seconds. The hood

command electronics will be excluded.

This function can be useful during the product

cleaning operations.

Just repeat the operation to reinsert the

electronics.

If the hood fails to operate correctly, briefly disconnect it from

the mains power supply for almost 5 sec. by pulling out the

plug. Then plug it in again and try once more before

contacting the Technical Assistance Service.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Elica Horizonte Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info