Bedienungsanleitung Elica NUAGE (Seite 15 von 244) (Alle Sprachen)

784521

Zoom out

Zoom in

Vorherige Seite

1/244

Nächste Seite

verify suitability of the materials in accordance with the type of

wall/ceiling. The wall/ceiling must be strong enough to take

the weight of the hood. Do not tile, grout or silicone this

appliance to the wall. Surface mounting only.

Operation

Use the high suction speed in cases of concentrated kitchen

vapours. It is recommended that the cooker hood suction is

switched on for 5 minutes prior to cooking and to leave in

operation during cooking and for another 15 minutes

approximately after terminating cooking.

The control panel consists of a backlit rotating disk.

•To put on and off the lights:

Press on the disk (T) to put on and off the lights

• To select the available suction speeds:

Turn the disk (T) clockwise to turn on and increase the suction

speed and counter-clockwise to decrease it, and to turn off the

hood.

The crown (L) lights to indicate the selected suction speed:

• L1 lit

speed 1 (minimum).

• L1 + L2 lit

speed 2 (medium).

• L1 + L2 + L3 lit

Speed 3 (maximum).

• L1 + L2 + L3 + L4 lit in flashing mode

Speed 4 (intensive), lasting for 5 minutes, then the hood is

placed automatically at speed 2

• L off:

Suction motor off

Filters’ Saturation Control

The hood is equipped with a device that indicates when it is

required to perform the filter maintenance

The saturation control device of the grease filter is always

active

The control device of the activated carbon filter is usually

turned off

To activate it, proceed as follows:

- Turn off the hood.

- Press the disk (T) for more than 5 seconds

The crown (L) lights completely, flashing, and a beep will be

heard: the control device of the charcoal filter is activated.

NB = to turn it off, turn off the hood, press the disk (T), L1 + L2

will be backlit, flashing; wait for the beep to confirm the

deactivation.

Grease filter saturation indicator

L1 + L2 flash when you have to perform maintenance of the

grease filter

Activated charcoal filter saturation indicator

L3 + L4 flash when you have to perform maintenance of the

activated charcoal filter

Reset of filter saturation signal

After filter maintenance, turn on the hood and press the disk

(T) for more than 5 seconds: you will hear a long tone (beep)

confirming the reset.

Note: In case of simultaneous signaling (grease filter and

activated charcoal filter saturation), you must repeat the reset

twice.

Maintenance

ATTENTION! Before performing any maintenance operation,

isolate the hood from the electrical supply by switching off at

the connector and removing the connector fuse.

Or if the appliance has been connected through a plug and

socket, then the plug must be removed from the socket.

Cleaning

The cooker hood should be cleaned regularly (at least with the

same frequency with which you carry out maintenance of the

fat filters) internally and externally. Clean using the cloth

dampened with neutral liquid detergent. Do not use abrasive

products. DO NOT USE ALCOHOL!

WARNING: Failure to carry out the basic cleaning

recommendations of the cooker hood and replacement of the

filters may cause fire risks.

Therefore, we recommend observing these instructions.

The manufacturer declines all responsibility for any damage to

the motor or any fire damage linked to inappropriate

maintenance or failure to observe the above safety

recommendations.

Grease filter - Fig. 5-14

Traps cooking grease particles.

This must be cleaned at least once a month (or when the filter

saturation indication system - envisaged on the model in

possession - indicates this necessity), using non-aggressive

detergents, in a dishwasher, which must be set to a low

temperature and a short cycle (Tmax: 70°C).

When washed in a dishwasher, metal parts may discolour

slightly.

The filter must be dried in an oven for one hour at a max

temperature of 100°C; if the filter is still moist, repeat the

operation.

Replace the filter at least every 2 years.

To remove the grease filter, pull the spring release handle.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Elica NUAGE Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info