741458
62
Zoom out
Zoom in
Vorherige Seite
1/248
Nächste Seite
DS80TC1L-001 62
3.2.4 Ceiling installation using a ceiling bracket Ref. 80TH5600133 and Power box IP66 Cod. 80PS9200133
Identify the camera installation point and proceed as follows:
Drill holes according to the type of wall (cement, wood, etc.) and the fastening devices used
Fasten the connection box to the ceiling.
Open the Power Box by unscrewing the four screws on the cover corners.
Insert in the wire grommets all the cables needed for the correct operation of the camera. For outdoor
installations, close hermetically the wire grommets, in order to maintain the IP protection grade.
Connect the mains power supply to the dedicated terminal pins, but do not power the Power Box until the
installation is completed.
Connect the RS485 serial line to AA BB terminal pins from the keyboard.
Connect the alarm sensors cables to the alarm input terminal pins 1 and 8 (for details, see the manual of Power
Box 80PS9200133).
Connect the video cable from the video device in use (DVR, monitor, etc.) to the female BNC connector placed
inside the box, taking care to put the rubber sheath for the protection of the metallic parts, in order to avoid that
these ones make electrical contact with internal electronic parts.
Configure the different Power Box dip-switches (for details, see the manual of Power Box 80PS9200133).
Close again the Power Box with the screws previously removed to open it.
Fasten the bracket Ref.80TH5600133 to the Power Box with rubber for base of up ring (ref. The picture as
below), taking care to pass the connection cable in the bracket, until it comes out from the opposite side, before
using the three provided screws.
Insert the connection cable in the threaded pipe, until it comes out from the opposite side.
Screw tightly the threaded pipe to the bracket, and lock it with one provide screw
Screw the bushing to the end of the case of the Dome. and lock it with one of two provide screws
62

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Elkron 80TC1L00133 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info