614483
93
Zoom out
Zoom in
Vorherige Seite
1/112
Nächste Seite
92
Stipple quilting with the AQ design patterns
First sew the center-most pattern of the quilt.
Remove the hoop AQ and quilt layers after the first section
is finished.
NOTE:
To remove the magnetic clamp, tilt and roll it off the frame.
Place the template sheet on the next section to sew and
adjust the position of the template sheet by aligning it with
the first pattern sewn.
Mark the reference lines for the second section.
Set the quilt layers in the hoop AQ and remove pins and
basting stitches from the hooped area.
Attach it to the machine (see the previous page).
NOTE:
Provide a wide space around the machine.
Prevent the free end of the quilt layers from hanging down
from the sewing surface. The use of the optional
clothsetter table is recommended.
Sew the second section. Repeat this step until the entire
area is filled with the stippling pattern.
If you need to sew the quilt upside down, flip the design
pattern in the editing mode after setting the hoop.
If the outer edges of each section do not align with each
otherdue to shrinkage, adjust the pattern size of the outer-
most section.
To adjust the pattern size, select the current pattern again
and press the key to open the single pattern adjusting
window.
Select the dimension or percentage, and press the “+” or
“–” key to adjust the pattern size.
Press the OK key and sew the design pattern in the
adjusted size.
CAUTION:
Make sure the hoop AQ is removed from the carriage
before to the home position. Otherwise the magnetic
clamps may hit the embroidery foot.
NOTE:
For the needle thread, the following brands are
recommended:
• Robison Cotton (50 weight)
• Coats Cotton
• Madeira Polyester (No. 120)
• Sulky Cotton (30 weight)
Reduce the sewing speed for a better result.
1
0
4
7
2
56
9
8
3
60mm
100%
90mm
100%
Adjust Design Dimensions
93

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Elna 9600 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info