Bedienungsanleitung Elnagh Motorhome (Seite 152 von 484) (Deutsch, Englisch, Französisch, Italienisch, Spanisch, Schwedisch)

632006

152

Zoom out

Zoom in

Vorherige Seite

1/484

Nächste Seite

7maIntenance

changIng a Wheel

Before changing a wheel, read the instruc-

tions and warnings in the chassis handbook

carefully.

Bear the following warnings in mind:

●Before changing a wheel, indicate the emergency state

of your vehicle using the means as set out in the High-

way Code.

●Before lifting the vehicle, apply the handbrake and en-

gage rst gear.

●Place the chocks so that they prevent the vehicle from

moving.

Never try and raise the vehicle with the

parking stabilisers and do not try and grasp

the body.

Never lie down under a raised vehicle.

●Do not start the engine on whilst the vehicle is raised.

●Changing the rims with others of a dierent type not

designed for your vehicle can adversely aect safety

when driving.

●To t dierent rims from the original ones, use appro-

priate nuts that are the right length and right taper for

the housing. These elements are vital for safe and cor-

rect tightening. Failure to observe this may compromise

safety when driving and aect the operation of the

braking system.

Models that do not have a spare wheel

come with an ination compressor with a 12

V power supply and current socket to be in-

serted in the cigar lighter housing plus a re-

pair kit for punctures. The packaging con-

tains the instructions for using the kit and

the compressor.

☞

The repair carried out using the kit is tem-

porary and is only designed to be used to

get to the nearest tyre repairer to have a

permanent repair done. If the tyre has a

puncture and has been repaired using the

kit supplied, drive slowly and very carefully:

do not exceed the top speed of 80 km/m for

any reason.

electrical system

fuSeS

●Ensure that when you replace a blown fuse, the device

to which it is connected is turned o. Replace with an

original fuse with the same value and colour.

●Locating the cause of a blown fuse is no easy task and

special skills are required: go to a car electrician or your

dealership if the new fuse also blows.

Replace a blown fuse only after you have

identied the cause.

●The main fuses of the vehicle are grouped in the fuse-

box protected by a plastic cover which may be located

on the front of the dinette on driver's side or passen-

ger's side according to the model.

●The type of fusebox varies according to the electronic

control unit tted on the vehicle. Two alternatives are

possible as shown and described in the following par-

agraphs.

Other fuses are located near the individual

consumers (e.g. the cassette toilet). If a con-

sumer is not working, after having checked

the condition of the fuses in the junction

unit, read the manufacturer’s instructions

for the device that is not working to check

the presence and location of the relevant

protective fuse.

☞

ne185 fuSeBox

F1 F3 F5 F7 F9F2 F4 F6 F8

F1: Fuse 5 A connected to the vehicle battery to power

the side marker lights

F2: Fuse 20 A connected to the vehicle battery to power

the refrigerator

F3: Fuse 15 A connected directly to the service battery

to power the step

F4: Fuse 30 A connected directly to the service battery

to power the WEBASTO/AUX

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Elnagh Motorhome Seite 152

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info