Bedienungsanleitung Elro AP5500 - Pro Alarm System (Seite 45 von 49) (Englisch)

708667

Zoom out

Zoom in

Vorherige Seite

1/49

Nächste Seite

LOW BATTERY INDICATION

Note: Before removing the battery cover on any device

to replace the battery ensure that the system is put into

Test mode to avoid initiating a Full Alarm condition.

The low battery indication for each system component

is as follows:

Control Panel

During a period of mains supply interruption the Control

Panel will be powered by the rechargeable backup

batteries. Under normal battery conditions the Power

LED on the panel will flash at 1s intervals. However,

under low battery conditions the Power LED will flash

at 3s intervals.

Remote Control

When the Remote Control is operated under low

battery conditions the transmit LED will continue to

flash after the button has been released.

Under normal battery conditions the LED will

extinguish when the button is released.

PIR Detectors

Under low battery conditions the LED behind the

detector lens will flash when movement is detected to

indicate that the battery needs to be replaced.

Under normal battery conditions the LED does not

illuminate unless the PIR detector is in Walk Test

mode.

Magnetic Contact Detectors

Under low battery conditions, when the Detector is

activated the transmit LED will be illuminated for

approximately 1s as the door/window is opened.

Under normal battery conditions the LED will not

illuminate as the Detector is operated, (unless the

Detector is in Test Mode with the battery cover

removed).

MAINTENANCE

Your Alarm System requires very little maintenance.

However, a few simple tasks will ensure its continued

reliability and operation.

CONTROL PANEL

The rechargeable batteries have a typical life of 3-4

years and need no maintenance during this period,

provided they are kept charged. The batteries will be

damaged if they are stored in a discharged state for

long periods.

DETECTORS AND REMOTE CONTROL

The Detectors require very little maintenance. The

batteries should be replaced once a year or when a low

battery status is indicated.

IMPORTANT: Should you, for any reason, have to

completely power-down the system (e.g. to move the

system to a new premises) first put the system into Test

mode before removing the Control Panel cover and

disconnecting the power supply and backup batteries.

BATTERIES

Before removing the battery cover on any device to

replace the battery, ensure that the system is put into

Test mode to avoid initiating an Alarm.

The specifications for replacement batteries are as

follows:

Remote Controls

1 x 3V CR2032 Lithium Cells

(or equivalent)

Magnetic Contact

Detectors

2 x 3V CR2032 Lithium Cells

(or equivalent)

PIR Detectors

1 x 9V PP3 Alkaline

Note: Where applicable only fit PP3 Alkaline type

batteries. Rechargeable batteries should NOT be

fitted.

At the end of their useful life the batteries should be

disposed of via a suitable Recycling Centre. Do not

dispose of with your normal household waste. DO

NOT BURN.

The Rechargeable batteries contain Sulphuric Acid –

DO NOT ATTEMPT TO OPEN THE CASING.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Elro AP5500 - Pro Alarm System Seite 45

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Elro AP5500 - Pro Alarm System

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info