Bedienungsanleitung Elro HIS20SF (Seite 54 von 62) (Deutsch, Englisch, Holländisch, Französisch)

536726

Zoom out

Zoom in

Vorherige Seite

1/62

Nächste Seite

Press to initiate ARM.

Press to initiate Partial Arm.

Press to initiate Holiday Arm.

Press to Disarm the system.

Press to turn OFF all of Green Control.

Press to turn the Siren OFF.

Press to turn the Siren ON.

Press to Listen-In via the Smart Home

Box Microphone.

Press to stop Listen-In

Note: Listen-in will be automatically cancelled after 5

minutes if not cancelled manually.

Press to interrogate the system status. A

message playing the latest status can be heard.

Press to read the status of AC power

supply.

Press to end the remote system control

and hang up the Smart Home Box line.

BATTERY MONITORING

All system devices continuously monitor their battery

condition. The Smart Home Box also monitors the

battery condition of all PIR and Magnetic detectors. If

the battery level of any device drops below acceptable

levels then its low battery indication will be activated.

In addition if any PIR or Magnetic Contact detector has

a low battery status it will be recorded by the Smart

Home Box and a message stored in the event log.

In the event of AC adaptor being disconnected from the

Smart Home Box, the Smart Home Box by consuming

the DC rechargeable battery can sustain 8 hours of

normal operation (under Disarm mode). However, the

battery for that device should be replaced as soon as

possible.

Note: Before removing the battery cover on any device

to replace the battery ensure that the system is put into

Test mode to avoid initiating a Full Alarm condition.

The low battery indication for each system component

is as follows:

Smart Home Box

During a period of mains supply interruption, the Smart

Home Box will be powered by the rechargeable backup

batteries. Under this circumstance, a radio signal will

be emitted to the central monitoring station or the

telephone voice dialer will call the set numbers right

away; this procedure will repeat again after 4 hours.

Under normal battery conditions the Power LED on the

panel will flash at 1s intervals.

Remote Control

When the Remote Control is operated under low

battery conditions the transmit LED will continue to

flash after the button has been released.

Under normal battery conditions the LED will

extinguish when the button is released.

PIR Detectors

Under low battery conditions the LED behind the

detector lens will flash when movement is detected to

indicate that the battery needs to be replaced.

Under normal battery conditions the LED does not

illuminate unless the PIR detector is in Walk Test

mode.

Magnetic Contact Detectors

Under low battery conditions, when the Detector is

activated the transmit LED will be illuminated for

approximately 1s as the door/window is opened.

Under normal battery conditions the LED will not

illuminate as the Detector is operated, (unless the

Detector is in Test Mode with the battery cover

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Elro HIS20SF Seite 54

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info