11. 10.
SETTING A SAFE VOLUME LEVEL
• If you continually listen to loud music, your hearing gradually adapts to it and gives you the
impression that the volume is lower.
• What seems normal to you can actually be damaging.
• To protect yourself from this, set the volume to a low level.
• Increase the volume slowly.
• Damage to your hearing can be extensive and cannot be reversed.
• If you notice a problem with your ears, please consult a doctor.
OPERATION
Press POWER (1) to switch the turntable on, press again to switch off; the POWER LED (2) lights up
in ON mode.
Remove the stylus protection (7) from the tone arm.
Be sure the tone arm is detached from tone arm rest before operation and secured again afterwards.
1. Press the POWER button (1) to switch the unit ON.
2. Set the speed selector (9) to the proper position depending on the record to be played
3. Place the record on the turntable. Use the supplied 45rpm insert (5), if necessary.
4. Set the cue lever (8) to up position to lift the tone arm from the tone arm rest.
5. Gently place the tone arm stylus (7) over the desired position on the record. The turntable will
start rotating.
6. Set the cue lever (8) to down position to release. The stylus will gently settle on the record.
7. Adjust the volume controls on your stereo system for the desired volume level.
8. At the end of the record the tone arm will return to its rest and the turntable will stop rotating. You
can stop the turntable at any time by pressing the LIFT button (3); the tone arm stylus (3) will
return to the tone arm rest.
IMPORTANT NOTES
• Do not touch tone arm or head shell when it is returning to the tone arm rest.
• Do not return the tone arm manually to the tone arm rest, only press the LIFT button (3).
• Engage the tone arm lock to avoid accidental stylus damage.
• Always clean records for a long life span of the stylus.
• The stylus may need replacing after long use.
STYLUS (NEEDLE) REPLACEMENT
1. Lift the tone arm stylus (7).
2. To remove the old stylus, pull out the stylus assembly and hold the head shell with the other
hand.
3. Install the new stylus by pushing it gently onto the cartridge (hold by the edge to prevent damage
to the stylus) until it clicks into place.
CARE AND MAINTENANCE
1. Press POWER (1) to turn the unit off after use and before cleaning.
2. Clean the unit with a soft and clean cloth moistened with lukewarm water.
3. Do not open the casing and repair by yourself. Always refer repairs to qualified service
personnel.
4. To reduce the risk of fire or electric shock do not expose this unit to rain or moisture. Do not block
ventilation holes.
5. No open flames, such as lighted candles, are to be placed on the unit.
6. Do not place the unit in closed book cases or racks without proper ventilation.
SPECIFICATIONS
Power supply : AC 230V ~ 50Hz
Power consumption : 5W
Speed settings : 33 / 45 / 78 rpm
Weight : 1.6 kg
Dimensions : 35 x 36 x 10 cm
SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT PRIOR NOTICE.
