4 | ENGLISH
8. Connector with cable
9. Tamper alarm button
10. Mouting bracket
2.0 Installing the battery
The 9V DC battery is located in the battery compartment, but not yet connected.
• Unscrew the top part from the bottom part of the smoke sensor (counter
clockwise).
• Unplug the connector cable (be careful).
• Open the battery compartment using the lever (5).
• Take out the battery from the compartment.
• Remove the foil of the battery.
• Connect the batter y to the battery connector inside the battery
compartment.
• Plug in the cable with connector back on the connector socket. Note the
colouring order of the cables:
Image 2. Connector colours
• The LED of the smoke detector will lit shortly after the connector is plugged
in. Do not close the housing yet.
3.0 Adding the smoke detector to an e-
Domotica e-Centre Base Station
You can now add the EM6590 e-Domotica Smoke Detector to your e-Domotica e-
Centre base station, follow these steps.
Tips:
If you already use 230V powered e-Domotica accessories, you are able to include the
smoke sensor on the location where the motion sensor needs to be mounted. The
benefit of doing this is that the e-Domotica accessories learn the communication route
to the e-Centre directly.
You might need to enable ‘Normal/High power’ (below the ‘Include’ button). This
option is available to include devices on a greater distance.
1. Make sure your computer is completely started.
2. Open your computer’s web browser.
