24
plastic teeth click.
- Reinsert the knob by positioning it in the right angle so that it correctly comes
into connect with its spindle and then pressing it down to the bottom.
TROUBLESHOOTING
SYMPTOM: In the “heating” mode, even though the setpoint knob
is on maximum, the red LED still remains OFF
and the relative output in the receiver also remains
OFF.
PROBABLE REASON: The red LED indicator does not continuously
indicate the status of the output relay. Furthermore,
the output relay in the receiver does not come on or
off instantly. The status is updated every 3 or 10
minutes. (See the “How it works” section.)
REMEDY: This is a normal operation.
SYMPTOM: When the batteries are inserted for the first time, the
red LED does not come on for 2 seconds.
PROBABLE REASON: The batteries are dead or have been inserted wrongly.
The polarity must be respected.
REMEDY: Correctly insert new batteries.
The “Installation” paragraph explains how to perform
the operation correctly.
PROBABLE REASON: Due to an extremely low consumption of electricity in
the circuit, if the batteries had already been inserted
9
9
9
ENGLISHPORTUGUÊS DEUTSCH ITALIANOFRANÇAISESPAÑOL
