Bedienungsanleitung Emmeti X-Evo - XX 17X3E R32 Outdoor unit (Seite 13 von 40) (Englisch)

667121

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

GBGB

6. EXTERNAL UNIT INSTALLATION

6.1 External unit installation

- Install the anti –vibration rubber pads under the external unit (acces-

sory provided separately) and place the unit on a raised part of at

least 10 cm as shown in Fig. A.

- Make sure about the stability and the levelling of the surface where

unit is placed.

- When several external units have to be installed, it is essential to

assure distances between the units which do not restrict air circu-

lation to the single units and to make maintenance operations easier

(Fig. B)

- In case of under roof installation or similar, please follow the indica-

tions shown in fig. C.

Fig. C

minimo 400 mm

Fig. B

A = minimum 60 cm

A = 10 cm

Fig. A

A = 10 cm

Nota:

Fixing brackets are accessories supplied separately

Attention!

Place the condensation water outlet so that no damage may be caused

to people or things.

It is advisable to be able to visually check the outlet drain at the end of

the piping, or alternatively insert a transparent section in the tubing

itself when it flows into an outlet which cannot be inspected.

Installation and maintenance activities on the air conditioners can

be done by personnel and companies holding appropriate certifi-

cate according to the Regulation (EC) Nr. 303/2008 which provides

the minimum requirements of the companies and of the personnel

about fixed units of refrigeration, air condition and heating pumps

which contain some fluorinated greenhouse gases, according to

the Regulation (EC) nr. 842/2006 of the European Parliament and

of the Council.

- Installation must be performed by qualified and authorized personnel.

- Do not attempt to install the unit by yourself.

- For any repairs, contact the service centre.

- Repairs of an electrical nature must be performed by qualified

electricians.

- Improper operations may cause serious harm to the user.

- You can find a list of service centres at the website www.emmeti.com

The right installation of the air conditioner assure its efficiency

Therefore we invite you to follow the instructions carefully about positio-

ning, installation, connexions and test listed in these manuals.

CAUTION

Danger cut: use of gloves.

If the conditions are met Arrange for work at height.

6.2 Outdoor unit condensation drain pipe

The outdoor unit is provided with a hole in the lower part of the frame,

which through a conical connection (supplied), drains the condensation

water.

- Insert the gasket on the supplied fitting

- Insert the fitting at the bottom of the outdoor unit

- Rotate the fitting 90 ° until you hear the click

- The hose clamp is clamped.

- The condensate discharge pipe must be slightly sloping to permit

natural outflow.

- It is advisable to use a sufficiently rigid plastic tube to prevent any

crushing of the same.

seal

Hole on the bottom of

the ' Outdoor unit

Drainage joint

seal

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Emmeti X-Evo - XX 17X3E R32 Outdoor unit Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Emmeti X-Evo - XX 17X3E R32 Outdoor unit

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info