ENDURO
®
autoSteady 39
Ref: AS201AFL/BFL-UM-TKI-0419-Rev. A
Unit fails to operate or operates intermittently:
Check the battery of the remote handset. If empty, renew the 9V battery.
Caravan battery could be empty. If empty, recharge completely or renew caravan battery before taking any
further action.
Caravan battery could be low. Check the voltage drop on the caravan battery, if this drops well below 10 volts,
charge or renew caravan battery
Caravan battery could be overloaded. Check your charging equipment and try to discharge the battery by
connecting/using a light or other load. If this does not give any result, renew caravan battery before taking any
further action.
Check the cable-connection between the caravan battery and the control unit.
Badly connected or corroded battery terminals can cause intermittent problems, check battery terminals, clean
and connect again.
Check the distance between the remote handset and the caravan is not more than 5 meters. If there is no
signal between the remote handset and the control unit, the autoSteady system will not function at all and the
green LED on remote handset will blink.
Check if there is any distortion signal (other transmitter, high power cables, Wifi etc.) that disturbs a good
communication between remote handset and control unit. If there is no good communication between the
control unit and remote handset, the autoSteady system will not function and the green LED on remote
handset will blink.
In general, all error messages will reset automatically after one minute. If this is not the case, reset the
electronics of the autoSteady system by switching off the autoSteady system via the isolation switch and the
remote handset for at least 15 seconds and then turn them on again.
Spindle will not turn, motor rotates freely:
The motor or gear is broken, or the connect-pin between the motor and spindle is broken, please contact your
ENDURO
®
autoSteady supplier
In case of any doubt, please contact your ENDURO
®
supplier.
