660387
6
Zoom out
Zoom in
Vorherige Seite
1/14
Nächste Seite
Charger Location & DC Connection
7
19. CHARGER LOCATION
CAUTION
a. Locate charger as far away from battery as DC cables permit.
b. Never place a charger directly above a battery being charged; gases or fluids from
battery will corrode and damage charger.
c. Do not operate charger in an enclosed area or in an area with restricted ventilation in
any way.
d. Never allow battery acid to drip on charger when reading electrolyte specific gravity
or filling a battery.
e. Do not set a battery on top of charger.
f. Do not install on or over combustible surfaces.
20. DC CONNECTION PRECAUTIONS
CAUTION
a. Connect and disconnect DC output clips only after setting any charger switches to
"off" position and removing AC cord from electric outlet. Never allow clips to touch
each other.
b. Attach charging clamps to battery and chassis described in section 21 and 22.
In-Vehicle Battery Charging Safety Precautions
8
21. FOLLOW THESE STEPS WHEN BATTERY IS INSTALLED IN A VEHICLE. A SPARK
NEAR BATTERY MAY CAUSE BATTERY EXPLOSION. TO REDUCE RISK OF A
SPARK NEAR A BATTERY:
CAUTION
a. Position AC and DC cords to reduce risk of damage by hood, door or moving engine parts.
b. Stay clear of fan blades, belts, pulleys and other parts that can cause injury to
persons.
c. Check polarity of battery posts. POSITIVE (POS, P, +) battery post usually has a
larger diameter than the NEGATIVE (NEG, N, ) post.
d. Identify if you have a negative or positive grounded vehicle. This can be done
by identifying which battery post NEGATIVE (NEG, N, ) OR POSITIVE (POS, P, +)
is connected to the chassis.
e. For a negative grounded vehicle: connect the RED POSITIVE (POS, P, +) cable
clamp or ring terminal first to the positive post of the battery, then connect the
BLACK NEGATIVE (NEG, N, ) cable clamp or ring terminal to the vehicle’s
chassis. Do not connect the black negative (NEG, N, ) cable clamp to metal fuel
lines or anywhere in proximity of the carburetor or the battery itself. Connect to
a heavy gauge metal part of the frame or engine block.
f. For a positive grounded vehicle: connect the BLACK NEGATIVE (NEG, N, ) cable
clamp or ring terminal first to the negative post of the battery, then connect the
RED POSITIVE (POS, P, +) cable clamp or ring terminal to the vehicle’s chassis. Do
not connect the red positive (POS, P, +) cable clamp to metal fuel lines or anywhere
in proximity of the carburetor or the battery itself. Connect to a heavy gauge metal
part of the frame or engine block.
g. Connect charger AC supply cord to a properly grounded fault protected electric outlet.
h. When charging is completed always disconnect AC power, remove clip from vehicle
chassis and then remove clip from battery terminal.
6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Enersys ODYSSEY Battery Charger wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info