Bedienungsanleitung Entrematic Ditec CROSS - IP1747 (Seite 3 von 20) (Englisch)

609373

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

IP1747EN  2011-09-07

1. GENERAL SAFETY PRECAUTIONS

This installation manual is intended for professionally competent personnel only.

Installation, electrical connections and adjustments must be performed in accordance with Good Working

Methods and in compliance with applicable regulations.

Before installing the product, carefully read the instructions. Bad installation could be hazardous. The packaging

materials (plastic, polystyrene, etc.) should not be discarded in the environment or left within reach of children,

as these are a potential source of hazard.

Before installing the product, make sure it is in perfect condition.

Do not install the product in an explosive environment and atmosphere gas or inammable fumes are a serious

hazard risk.

Before installing the motors, make all structural changes relating to safety clearances and protection or segre-

gation of all areas where there is risk of being crushed, cut or dragged, and danger areas in general.

Make sure the existing structure is up to standard in terms of strength and stability. The motor manufacturer

is not responsible for failure to use Good Working Methods in building the frames to be motorized or for any

deformation occurring during use.

The safety devices (photocells, safety edges, emergency stops, etc.) must be installed taking into account:

applicable laws and directives, Good Working Methods, installation premises, system operating logic and the

forces developed by the motorized gate.

The safety devices must protect any areas where the risk exists of being crushed, cut or gragged, or where

there are any other risks generated by the motorized gate.

Apply hazard area notices required by applicable regulations.

Each installation must clearly show the identication details of the motorized gate.

Before making power connections, make sure the plate details correspond to those of the power mains.

Fit an omnipolar disconnection switch with a contact opening gap of at least 3 mm.

Make sure an adequate residual current circuit breaker and overcurrent cutout are tted upstream of the elec-

trical system. When necessary, connect the motorized gate to a reliable earth system made in accordance with

applicable safety regulations.

During installation, maintenance and repair, interrupt the power supply before opening the lid to access the

electrical parts.

To handle electronic parts, wear earthed antistatic conductive bracelets. The motor manufacturer declines

all responsibility in the event of component parts being tted that are not compatible with the safe and

correct operation.

For repairs or replacements of products only original spare parts must be used. The installer shall provide all

information relating to automatic, manual and emergency operation of the motorized gate, and provide the user

with operating instructions.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Entrematic Ditec CROSS - IP1747 Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Entrematic Ditec CROSS - IP1747

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info