STORAGE TIPS
If you do not plan to use your humidier for an extended period of time, such as during
the summer months, it is important that you follow these instructions to help prevent
problems from developing in the unit.
1. Clean your humidier as instructed in the section titled, “Cleaning and
Maintenance”.
2. Make sure all water is emptied from the tanks and the hot and cold water reservoirs.
3. Dry your unit thoroughly.
4. Leave the tank caps o to expose the tanks to air.
5. Pack your humidier in its original carton and store it in a cool, dry place.
SERVICE
DO NOT attempt to repair this humidier yourself. For repairs covered under the
warranty, contact Kaz Incorporated by telephone or mail for a Return Authorization
Number.
TROUBLESHOOTING
TROUBLE POSSIBLE CAUSES SOLUTION
Unit does not mist Unit is not plugged in Plug in unit
Power failure Check circuit breaker
Water tanks empty Remove and rell
Power switch not turned on Turn on switch to LO or HI
Unit not reset after relling tanks Reposition water tanks
Water tank not properly Reposition water tanks
located on base unit
Humidity level set is achieved Turn Relative Humidity
Control to higher setting
Using distilled or treated water Add “pinch” of table salt
which does not contain
enough ions
Only one tank empties Move unit to level surface.
Raise end with full tank.
Water leaks from unit Tank cap or tank cap Tighten cap.
gasket is missing or improperly Replace tank cap
positioned or reposition cap
gasket.
Moist air output low Mineral buildup in hot water Clean unit as per
reservoir instructions.
Rell indicator light on Water level is below water Rell water tanks
level probes and mount tanks on base
Water level probes Clean probes per
are covered with lm cleaning instructions
Mineral buildup in hot water Clean unit per
reservoir cleaning instructions
