Bedienungsanleitung Epson EB-695Wi (Seite 42 von 253) (Englisch)

675175

Zoom out

Zoom in

Vorherige Seite

1/253

Nächste Seite

Turning On the Projector

Turn on the computer or video equipment you want to use after you turn on

the projector.

Connect the power cord to the projector's power inlet and plug it into

an electrical outlet.

The projector's power indicator turns blue. This indicates that the

projector is receiving power, but is not yet turned on (it is in standby

mode).

Press the power button on the control panel or remote control to turn

on the projector.

The projector beeps and the status indicator flashes blue as the

projector warms up. Once the projector is warmed up, the status

indicator stops flashing and turns blue.

Try the following if you do not see a projected image.

• Turn on the connected computer or video device.

• Change the screen output from the computer when using a laptop

computer.

• Insert a DVD or other video media, and press play (if necessary).

• Press the [Source Search] button on the control panel or remote control to

detect the source.

• Press the button for the desired video source on the remote control.

• If the Home screen is displayed, select the source you want to project.

Warning

• Never look into the projector lens when the lamp is on. This can damage your

eyes and is especially dangerous for children.

• When turning on the projector at a distance using the remote control, make sure

there is no one looking into the lens.

• During projection, do not block the light from the projector with a book or other

objects. If the light from the projector is blocked, the area on which the light

shines becomes hot which could cause it to melt, burn, or start a fire. Also, the

lens may get hot due to the reflected light which could cause the projector to

malfunction. To stop projection, use the A/V Mute function, or turn off the

projector.

• A mercury lamp with high internal pressure is used as the projector's light

source. If the lamp is subjected to vibrations or shocks, or if it is used for an

overly extended length of time, the lamp may break or it may not turn on. If the

lamp explodes, gases may escape and small fragments of glass may be scattered

which could cause an injury. Be sure to observe the instructions below.

• Do not disassemble or damage the lamp or subject it to any impacts.

• Do not bring your face close to the projector while it is in use.

• Particular care should be taken when the projector is installed to a wall or

ceiling, as small pieces of glass may fall down when the lamp cover is removed.

When cleaning the projector or replacing the lamp yourself, be very careful

not to allow such pieces of glass to get into the eyes or mouth.

If the lamp breaks, ventilate the area immediately, and contact a doctor if any

fragments of broken glass are inhaled or get into the eyes or mouth.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Epson EB-695Wi Seite 42

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Epson EB-695Wi

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info