675248
170
Zoom out
Zoom in
Vorherige Seite
1/255
Nächste Seite
Indicator Cause Remedy or Status
Power Status Lamp Temp Filter
Blue -
Flashing
Status
varies
Status
varies
Orange -
Flashing
Status
varies
High Temp Warn‐
ing
This is not an error. However, if the temperature rises too high again, projection stops automatically.
Check the following two points.
Check that the air filter and air exhaust vents are clear, and that the projector is not positioned against a
wall.
If the air filter is clogged, turn off the power, remove the power cord from the electrical outlet, and then
clean or replace them.
s "Cleaning the Air Filter" p.191
s "Replacing the Air Filter" p.197
Blue -
Flashing
Status
varies
Orange -
Flashing
Status
varies
Status
varies
Replace Lamp Replace it with a new lamp.
s "Replacing the Lamp" p.194
If you continue to use the lamp after the replacement period has passed, the possibility that the lamp may
explode increases. Replace it with a new lamp as soon as possible.
Status
varies
Status
varies
Orange -
Flashing
Status
varies
Status
varies
Installation posi‐
tion warning (non-
support position,
installation angle)
A message is displayed, and projection stops automatically after about five minutes. Check the installation
angle of the projector.
Check the guaranteed operating range.
s "Warning and Cautions on Installation" p.3
Check if Direction in the Configuration menu is set correctly.
s "Setting the direction" p.28
Blue -
Flashing
Status
varies
Status
varies
Status
varies
Orange -
On
Low Air Flow This is not an error. However, projection stops automatically if the airflow falls any further.
"The air filter is clogged. Clean or replace the air filter."is displayed. Check the following points.
Check that the air filter and air exhaust vents are clear, and that the projector is not positioned against a
wall.
If the air filter is clogged, turn off the power, remove the power cord from the electrical outlet, and then
clean or replace them.
s "Cleaning the Air Filter" p.191
s "Replacing the Air Filter" p.197
If the error continues after checking the points above, stop using the projector, remove the power plug
from the electrical outlet, and contact your local dealer or the nearest address provided in the Epson
Projector Contact List.
s Epson Projector Contact List
Reading the Indicators
170
170

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Epson EB-G7400U wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Epson EB-G7400U

Epson EB-G7400U Bedienungsanleitung - Deutsch - 269 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info