617841
109
Zoom out
Zoom in
Vorherige Seite
1/135
Nächste Seite
Troubleshooting
108
The Panel Alignment adjustment is not satisfactory or difficult to achieve
Check Remedy
Does the Projection setting match the pro-
jector's installation position?
The panel alignment adjustment method changes depending
on the Projection setting. Make sure the Projection setting
matches the projector's installation position.
s Settings - Pro-
jection p.90
Is the projection surface suitable? For best results, the projection surface should not be colored or
textured, otherwise the adjustment grids will be difficult to align.
Project onto a screen and so on that is white and does not have
a pattern.
Were adjustments made immediately after
the projector was turned on?
To obtain stable image quality, leave the projector on for a while
before making adjustments.
Is the image size suitable? The projected image should be a minimum of 60".
Is the shifted color magenta?
Adjust R (red) and B (blue) for Select Color since magenta is a
mixture of red and blue.
Do the lines in the pattern look fuzzy or out of
focus?
Adjust the focus.
s p.32
Problems when projection starts
The projector does not turn on
Check Remedy
Is the power turned on?
Press the
button on the remote control or the button
on the control panel.
Is Child Lock set to On? When Child Lock is set to On from the Configuration menu, hold
down the
button on the control panel for approximately
three seconds, or perform operations from the remote control.
s Settings - Lock Setting - Child Lock p.90
Do the indicators turn on and off when the
power cord is touched?
Turn off the projector, and then disconnect and reconnect the
projector's power cord. If the problem continues, stop using the
projector, remove the power plug from the electrical outlet, and
contact your local dealer or the nearest projector information
center.
s Epson Projector Contact List
Problems with the remote control
The remote control does not respond
Check Remedy
Is the remote control light-emitting area
pointing towards the remote receiver on the
projector during operation?
Point the remote control towards the remote receiver. Also,
check the operating range.
s p.25
Is the remote control too far from the projec-
tor?
Check the operating range.
s p.25
Is direct sunlight or strong light from fluores-
cent lamps shining onto the remote receiver?
Set the projector up in a location where strong light does not
shine onto the remote receiver.
109

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Epson EH-LS10000 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Epson EH-LS10000

Epson EH-LS10000 Bedienungsanleitung - Deutsch - 133 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info