Bedienungsanleitung Epson EMP-S5 (Seite 43 von 78) (Englisch)

500368

Zoom out

Zoom in

Vorherige Seite

1/78

Nächste Seite

Problem Solving

f The message "Not supported." is displayed

f The message "No Signal." is displayed

f Images are fuzzy or out of focus

Check Remedy

Is the image signal format setting correct? Change the setting according to the signal for the connected equipment. s"Signal"-"Video Signal" p.26

Do the image signal resolution and the refresh rate

correspond to the mode?

Refer to the computer's documentation for how to change the image signal resolution and the refresh rate

output from the computer. s "List of Supported Monitor Displays" p.70

Check Remedy

Are the cables connected correctly? Check that all the cables required for projection are securely connected. s Quick Start Guide

Is the correct input port selected? Change the image by pressing the [Source Search] button on the remote control or the control panel.s p.13

Is the power for the computer or video source turned on? Turn the power on for the equipment.

Are the image signals being output to the projector? If the image signals are only being output to the computer's LCD monitor or to the accessory monitor, you

need to change the output to an external destination as well as the computer's own monitor. For some

computer models, when the image signals are output externally, they no longer appear on the LCD monitor

or accessory monitor. sComputer's documentation, under a title such as "External output" or "Connecting

an external monitor".

If the connection is made while the power of the projector or computer is already turned on, the function

[Fn] key that changes the computer's image signal to external output may not work. Turn the power for the

computer and the projector off and then back on again. s Quick Start Guide

Check Remedy

Is the focus adjusted correctly? Turn the focus ring to adjust the focus. s Quick Start Guide

Is the projector at the correct distance? For EMP-83/822/X5, the recommended projection distance for Wide ranges from 84 to 867 cm, and for Tele

from 101 to 1041 cm. For EMP-S5, the recommended projection distance ranges from 87 to 1050 cm.

Setup within this range. s p.59

Is the Keystone adjustment value too large? Lower the projection angle to reduce the amount of keystone correction. s Quick Start Guide

Has condensation formed on the lens? If the projector is suddenly taken from a cold environment to a warm environment, or if sudden ambient

temperature changes occur, condensation may form on the surface of the lens, and this may cause the images

to appear fuzzy. Set the projector up in the room about one hour before it is used. If condensation forms on

the lens, turn the projector off and wait for the condensation to disappear.

Only when projecting images from a video source

Only when projecting computer images

Only when projecting images from a laptop

computer or a computer with a built-in LCD screen

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Epson EMP-S5 Seite 43

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Epson EMP-S5

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info