215219
24
Zoom out
Zoom in
Vorherige Seite
1/100
Nächste Seite
22-Projector Care
Appendices
Appendix.fm3/9/04
fLamp replacement period
It is time to change the lamp when the "Replace the lamp" message appears
in the bottom left hand corner of the screen at the commencement of
projection and remains for 30 seconds.
It is also time to change the lamp when the Warning indicator flashes red at
0.5 second intervals.
fReplacing the lamp
(Spare lamp: ELPLP29)
1
Turn off the projector and wait for the
cool-down period to end. (Approx. 20
seconds)
Remove the power cable and wait for the
lamp to cool down. (Approx. 1 hour)
2
Open the lamp cover.
Lift the lamp cover by putting your fingers in
the latches and lifting upwards.
3
Loosen the fixing screws holding the
lamp in place.
4
Remove the old lamp.
5
Install the new lamp.
Press the lamp until it clicks into place, then
tighten the two fixing screws.
6
Replace the lamp cover.
First insert the tabs, and then press down on
the opposite side until it clicks into place.
p
The time when the replacement message appears varies depending on the colour mode which has been used.
If Theatre Black has been used continuously: About 2900 hours
If other modes have been used continuously: About 1900 hours
When this message is displayed, please replace the lamp as quickly as possible.
The lamp may explode if you continue to use it beyond the lamp replacement period.
Some lamps may stop operating before the replacement message is displayed. It is recommended that you have a
replacement lamp ready in case this happens.
Replacement lamps can be purchased at your nearest dealer.
c
Wait until the lamp has cooled down sufficiently before opening the lamp cover. It takes a further one hour after the cool-
down period has finished for the lamp to be cool enough.
When the lamp is broken, replace it with a new lamp, or contact your dealer for further advice. If replacing the lamp
yourself, be careful to avoid pieces of broken glass.
USERS_E.BOOK Page 22 Tuesday, March 9, 2004 12:52 PM
24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Epson emp tw10h lcd projector wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Epson emp tw10h lcd projector

Epson emp tw10h lcd projector Bedienungsanleitung - Deutsch, Englisch, Französisch - 100 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info