Bedienungsanleitung Epson L5290 series Ecotank (Seite 14 von 288) (Englisch)

771491

Zoom out

Zoom in

Vorherige Seite

1/288

Nächste Seite

Printer Advisories and Warnings

Read and follow these instructions to avoid damaging the printer or your property. Make sure you keep this

manual for future reference.

Advisories and Warnings for Setting Up the Printer

❏Do not block or cover the vents and openings in the printer.

❏Use only the type of power source indicated on the printer's label.

❏Avoid using outlets on the same circuit as photocopiers or air control systems that regularly switch on and o.

❏Avoid electrical outlets controlled by wall switches or automatic timers.

❏Keep the entire computer system away from potential sources of electromagnetic interference, such as

loudspeakers or the base units of cordless telephones.

❏e power-supply cords should be placed to avoid abrasions, cuts, fraying, crimping, and kinking. Do not place

objects on top of the power-supply cords and do not allow the power-supply cords to be stepped on or run over.

Be particularly careful to keep all the power-supply cords straight at the ends and the points where they enter

and leave the transformer.

❏If you use an extension cord with the printer, make sure that the total ampere rating of the devices plugged into

the extension cord does not exceed the cord's ampere rating. Also, make sure that the total ampere rating of all

devices plugged into the wall outlet does not exceed the wall outlet's ampere rating.

❏If you plan to use the printer in Germany, the building installation must be protected by a 10 or 16 amp circuit

breaker to provide adequate short-circuit protection and over-current protection for the printer.

❏When connecting the printer to a computer or other device with a cable, ensure the correct orientation of the

connectors. Each connector has only one correct orientation. Inserting a connector in the wrong orientation

may damage both devices connected by the cable.

❏Place the printer on a at, stable surface that extends beyond the base of the printer in all directions. e printer

will not operate properly if it is tilted at an angle.

❏Allow space above the printer so that you can fully raise the document cover.

❏Leave enough space in front of the printer for the paper to be fully ejected.

❏Avoid places subject to rapid changes in temperature and humidity. Also, keep the printer away from direct

sunlight, strong light, or heat sources.

Advisories and Warnings for Using the Printer

❏Do not insert objects through the slots in the printer.

❏Do not put your hand inside the printer during printing.

❏Do not touch the white at cable and ink tubes inside the printer.

❏Do not use aerosol products that contain ammable gases inside or around the printer. Doing so may cause re.

❏Do not move the print head by hand; otherwise, you may damage the printer.

❏Be careful not to trap your ngers when closing the scanner unit.

❏Do not press too hard on the scanner glass when placing the originals.

Important Instructions

Printer Advisories and Warnings

Advisories and Warnings for Using the Printer

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Epson L5290 series Ecotank Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Epson L5290 series Ecotank

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info