Bedienungsanleitung Epson Stylus Photo RX620 (Seite 16 von 19) (Englisch)

584075

Zoom out

Zoom in

Vorherige Seite

1/19

Nächste Seite

Epson Stylus Photo RX620

11/04 Epson Stylus Photo RX620 - 15

If you don’t see any improvement after cleaning three or four

times, check the troubleshooting solutions in the on-screen

Reference Guide. You can also turn the RX620 off and wait

overnight—this allows any dried ink to soften—and then try

cleaning the print head again.

Caution:

When you don’t turn on your RX620 for a long time, the print quality

can decline. It’s a good idea to turn it on at least once a month to

maintain good print quality.

Replacing Ink Cartridges

When you print with low or empty ink cartridges, you’ll see a

message on your RX620 screen. When your ink starts getting

low, make sure you have replacement cartridges available. You

can’t print if a cartridge is empty.

Check the icon in the upper

right corner to see which

cartridge is low or empty:

If you can’t see the icon

clearly enough, press the

Setup button, then press the

d button to select

LCD Contrast Adjustment then press the

OK button. Use the l and r buttons to decrease or increase

the contrast as necessary to see the icon clearly, then press the

OK button.

When a cartridge is more than six months old, you may need

to replace it if printouts don’t look their best. If the quality

doesn’t improve after cleaning and aligning the print head,

you may need to replace the cartridge.

Checking the Ink Supply

To check your ink supply, do the following:

1. Press the

Setup button to enter setup mode.

2. Press the u and d buttons to select

Ink Levels, then press

the

OK button.

You see a graphic with the amount of ink available in each

cartridge:

B (Black) C (Cyan), LC (Light Cyan),

M (Magenta), LM (Light Magenta), and Y (Yellow).

3. When you’re done checking the ink levels, press the

button.

When your ink starts getting low, make sure you have

replacement cartridges available. You can’t print if a cartridge

is empty.

Ink Cartridge Precautions

Warning:

Keep ink cartridges out of the reach of children.

If ink gets on your hands, wash them thoroughly with soap and

water. If ink gets in your eyes, flush them thoroughly with water.

Caution:

To avoid damaging the printer, never move the print head by hand.

You can’t print if an ink cartridge is empty. Leave the empty

cartridge installed in the RX620 until you have obtained a

replacement. Otherwise the ink remaining in the print head nozzles

may dry out.

Removing and Installing Ink Cartridges

Be sure you have a new ink cartridge before you begin. Once

you start replacing a cartridge, you must complete all the steps

in one session.

1. If an ink cartridge is empty:

Look at the icon in the upper right corner of the LCD

screen to see which cartridge is empty, then press the

button.

If an ink cartridge is low:

Press the

Setup button to enter setup mode. Press the u

and d buttons to select

Ink Cartridge, press OK, then press

OK again. Look at the icon in the upper right corner of the

LCD screen or check the ink levels as described in

“Checking the Ink Supply” above.

2. Lift open the scanner section, as shown, making sure to

keep the scanner lid closed on top.

Ink levels

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Epson Stylus Photo RX620 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Epson Stylus Photo RX620

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info