Bedienungsanleitung Epson STYLUS PRO 4910 (Seite 20 von 177) (Englisch)

617721

Zoom out

Zoom in

Vorherige Seite

1/177

Nächste Seite

❏ When using the printer, observe the operating

temperature and humidity range described in the

"Specifications Table". U “Specifications Table”

on page 163

Even when the conditions above are met, you may

not be able to print properly if the environmental

conditions are not suitable for the paper. Be sure to

use the printer in an environment where the paper's

requirements are met. For more details, see the

manual supplied with the paper.

Also, when operating in dry areas, air conditioned

environment, or under direct sunlight, maintain

the appropriate humidity.

❏ Capping may not occur (the print head is not

positioned on the right-hand side) if the printer is

turned off during a paper jam or when an error

occurs. Capping is a function for automatically

covering the print head with a cap (lid) to prevent

the print head from drying out. In this case, turn on

the power and wait a while until capping is

performed automatically.

❏ When the power is on, do not remove the power

plug or cut the power at the breaker. The print head

may not be capped properly. In this case, turn on the

power and wait a while until capping is performed

automatically.

❏ Do not move the print head by hand.

Notes when not using the printer

If you are not using it, note the following points when

storing the printer. If it is not stored correctly, you may

not be able to print properly the next time it is used.

❏ If you do not print for a long time, the print head

nozzles may become clogged. We recommend that

you print once a week to prevent the print head

from clogging.

❏ If the paper is left in the printer, the roller of the

paper presser may leave a mark on the surface of the

paper. This can also cause wavy or curled paper

resulting in paper feeding problems or the print

head could be scratched. Remove any paper when

storing.

❏ Store the printer after confirming that the print

head has been capped (the print head is positioned

at the far right). If the print head is left uncapped for

a long time, the print quality may decline.

Tip:

If the print head is not capped, turn the printer on, and

then turn it off.

❏ Close the roll paper cover and printer cover before

storing. If you are not using the printer for a long

time, put an anti-static cloth or cover on the printer

to prevent dust. The print head nozzles are very

small, and they can become clogged easily if fine

dust gets on the print head, and you may not be able

to print properly.

❏ If you have not used the printer for a long time,

check the print head for clogging before you start

printing. Perform head cleaning if the print head is

clogged.

U “Checking for clogged nozzles” on page 113

Notes on handling ink cartridges

Note the following points when handling ink cartridges

to maintain good print quality.

❏ The included ink cartridges and installed

Maintenance Box 1 are just for initial ink charging.

You may need to replace the ink cartridge or

Maintenance Box 1 soon.

❏ We recommend storing ink cartridges at normal

room temperature, and to use them by the expiry

date printed on the cartridge packaging.

❏ For the best printing results, use up the ink cartridge

within six months of installation.

❏ If you move ink cartridges from a cold place to a

warm place, leave it at room temperature for more

than four hours before using the ink cartridge.

❏ Do not touch the green IC chip on the ink

cartridges. You may not be able to print properly.

❏ Install ink cartridges into all slots. You cannot print

if any slot is empty.

Epson Stylus Pro 4900/4910 User's Guide

Introduction

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Epson STYLUS PRO 4910 Seite 20

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Epson STYLUS PRO 4910

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info