F Roll support
Rest media temporarily on these supports when removing the take-up roll. There are two supports: one on the left
and one on the right.
G Auto switch
Use this switch to select the auto take-up direction. Choose Off to disable auto take-up.
H Manual switch
Use this switch to select the manual take-up direction. The selected option takes effect when the Auto switch is in
the Off position.
I Casters
There are two casters on each leg. Once installation is complete, the front casters should be kept locked while the
printer is in use.
J Waste ink bottle holder
Place the waste ink bottle in this holder.
K Adjuster
The adjusters keep the printer in place. After installing the printer, keep it securely in place during use.
L Waste ink bottle
Waste ink collects in this bottle.
Replace with a new waste ink bottle when the level approaches the line.
M Waste ink tube
Waste ink is discharged from this tube. Be sure the end of this tube is in the waste ink bottle while the printer is in
use.
N Ink tank
Holds ink used for printing.
O Slider
U “Slider” on page 10
P Lock lever
Raise the lock lever to unlock the slider for removal when replacing the chip unit. Always lower the lock lever into
the locked position after inserting the slider.
Q Chip unit check lamp
This lamp turns on when a message related to the chip unit is displayed.
On : An error occurred. Check the contents of the error on the control panel’s screen.
Off : No error.
R AC inlet
Connects the power cable.
S LAN port
U “LAN port” on page 10
T USB port
Connects the USB cable.
SC-F7000 Series User’s Guide
Introduction
8
