F Roll core holder locking screw
The locking screws keep the roll core holders in place once they have been attached to the roll core. There are same
parts on both the left and the right.
G Roll support
Rest media temporarily on these supports when removing the take-up roll. There are same parts on both the left and
the right.
H Auto switch
Use this switch to select the auto take-up direction. Choose Off to disable auto take-up.
I Manual switch
Use this switch to select the manual take-up direction. The selected option takes effect when the Auto switch is in
the Off position.
J Casters
There are two casters on each leg. Once installation is complete, the front casters should be kept locked while the
printer is in use.
K Airflow vents
Allows air to flow into the printer. Do not obstruct these vents.
L Waste ink bottle holder
Place the waste ink bottle in this holder.
M Adjuster
The adjusters keep the printer in place. After installing the printer, keep it securely in place during use.
N Waste ink bottle
Waste ink collects in this bottle.
Replace with a new waste ink bottle when the level approaches the line.
O Waste ink tube
Waste ink is discharged from this tube. Be sure the end of this tube is in the waste ink bottle while the printer is in
use.
P Ink cartridges
Install all ink cartridges into each slot.
Q Lock levers
Raise the levers to unlock the ink cartridges prior to removal. Lower the levers to lock the cartridges in place after
insertion.
R Cartridge check lamp
This lamp lights when an ink cartridge error occurs.
On : An error occurred. Check the contents of the error on the control panel's screen.
Off : No error.
S AC inlet #1/AC inlet #2
Connects the power cable. Be sure to connect both cables.
EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
Introduction
12
