❏ Do not load more than the maximum number of sheets specied for the paper. For plain paper, do not load
above the line just under the
d
symbol inside the edge guide.
❏ Insert the paper cassette all the way.
❏ When paper does not feed aer replacing the maintenance rollers, the rollers may not have been replaced
correctly. Check if they have been replaced correctly.
❏ If you have added optional paper cassette units, you need to make settings in the printer driver.
❏ When a no-paper error occurs although paper is loaded in the rear paper feed, load paper again in the center of
the rear paper feed.
❏ When multiple sheets of paper feed at once during manual 2-sided printing, remove any paper which is loaded
in the paper source before you reload the paper.
❏ Load and eject paper without printing to clean the paper path.
❏ Close the front cover if you opened it during printing. Keeping the front cover open during printing pauses the
print job.
❏ Do not open rear cover 1 of paper cassette 1 or the rear cover of the optional paper cassette unit while printing.
is causes a paper jam.
❏ e maintenance rollers may be at the end of their service life. Select Setup > Maintenance > Maintenance
Roller Information > Maintenance Roller Status, and then replace the maintenance rollers as necessary.
❏ Make sure the paper size and paper type settings of the paper source are correct.
Related Information
& “Environmental Specications” on page 175
&
“Available Paper and Capacities” on page 38
&
“Paper Handling Precautions” on page 38
&
“Loading Paper in the Paper Cassette” on page 42
&
“Loading Paper in the Rear Paper Feed” on page 44
&
“Loading Paper in the Front Paper Feed Slot” on page 46
&
“Replacing Maintenance Rollers in Paper Cassette 1” on page 111
&
“Replacing Maintenance Rollers in Paper Cassette 2 to 4” on page 115
& “Setting the Optional Paper Cassette Unit in the Printer Driver” on page 188
& “Cleaning the Paper Path” on page 125
& “Setting the Paper Size and Paper Type for Each Paper Source” on page 47
Original Does Not Feed in the ADF
❏ Use originals supported by the ADF.
❏ Load originals in the correct direction, and slide the edge guides against the edges of the originals.
❏ Clean the inside of the ADF.
❏ Do not load above the line just under the
d
symbol inside the edge guide.
Related Information
& “Available Originals for the ADF” on page 49
& “Placing Originals on the ADF” on page 49
User's Guide
Solving Problems
153
