Bedienungsanleitung Ergofix 77207-1 (Seite 23 von 44) (Deutsch, Englisch, Holländisch, Französisch)

621623

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

• Keep your hands well away from any splits and cracks which open in the log;

these may close suddenly and crush or amputate your fingers.

• Never force the log splitter for more than 5 seconds keeping the cylinder

under pressure in the attempt to split excessively hard wood. After this time

interval, the oil under pressure is overheated and the machine could be

damaged. It is thus better to stop and rotate the log by 90° to see whether it can

be split in a different position. In any case, if you are not able to split the log, this

means that its hardness exceeds the capacity of the machine and thus that the

log should be discarded so as not ot damage the log splitter.

• Do not force the blade by pushing the log on the upper part; as this can cause

the blade to break or damage the body of the machine. Always set the log on

the guides.

• Never leave the machine unattended while it is running. If you leave the

machine, even for a short time, remove the power supply or any possible cause

of accidental start-up.

• The log splitter must never be used by an operator who is under the influence

of alcohol, drugs, medicines, or who is tired. A clear mind is essential for safety.

• Never request the assistance of another person to help you remove a jammed

log.

• Check that the electric circuit is adequately protected and that it corresponds

with the power, voltage and frequency of the motor. Check that there is a

ground connection and a regulation differential switch upstream.

• Use cables with a section of 5 x 1,5 mm². Avoid use of free and inadequately

insulated connections. Connections must be made with protected materials

suitable for outdoor use. Do not use cables over 10 metres long, as excessively

long cables or those with inadequate section can cause voltage drops that

prevent motor from developing its full power.

• Never open the pushbutton box on the motor. Should this be necessary,

contact a qualified electrician.

• Make sure that the machine and the cable never come in contact with water.

• Treat the power cable with care. Do not attempt to move the machine by pulling

the cable. Do not yank the cable to unplug it; keep the cable away from

excessive heat, oil and sharp objects.

• Never leave the machine unattended with the power supply "on". Also

disconnect the power cable when not in use, when carrying out maintenance

work, when changing attachment or moving the machine.

4. SET UP FOR OPERATION

UNPACKING: at least 2 people are required to unpack the log splitter package.

After unpacking proceed as follows:

1 Assemble the wheels and the axle.

2 Fix the switch box with 2 x screw with screw nut.

3 Mount the control levers.

4 Assemble the work table(adjustable in height)

5 Pour the supplied oil in the oil tank through the funnel with hose.

6 Check the direction of motor rotation.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ergofix 77207-1 Seite 23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info