621620
22
Zoom out
Zoom in
Vorherige Seite
1/36
Nächste Seite
21
Changing speeds
The belt is shown positioned on the second steps from the outside end of the
pulley in fig. 9. This causes the lathe to turn at 2520 rpm. Refer to fig. 10; suppose
you wish to run the lathe slower, after refering to the speed chart (say 1560 rpm)
you must shift the belt inward.
Caution: make sure the power cord is removed from the outlet before attempting to
change the belt position.
Raise the belt guard:
- to make the lathe go slower shift belt inward.
- to make the lathe go faster shift belt outward.
Rotate the motor pulley counterclockwise with the left hand while pushing on the
belt with you right hand. Continue to rotate the pulley while pushing on the belt
until it “climbs” down into the next step of the motor pulley.
Now rotate the spindle pulley clockwise with your right hand while pushing on the
belt with your left hand. The belt will climb up into the third next of the spindle
pulley.
Rotate the spindle pulley clockwise with your right hand. Pull on the belt while
rotating the pulley until it climbs down into the next smaller step. Now rotate motor
pulley counterclockwise with your left hand while pulling on the belt with your right
hand. The belt will climb up into the next larger step.
Belt tension adjustment
Belt tension is provided by the weight of the motor pivoting the motor mounting
bracket downward through the hinge of the hinge bracket. To decrease the belt
tension, tighten the adjustment bolt located in the corner of the motor mounting
bracket, thus restricting downward pivoting travel. Conversly, loosening the
adjusting bolt allows increased pivot on the bracket, thus increasing belt tension.
22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Ergofix 79585 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info