480732
12
Zoom out
Zoom in
Vorherige Seite
1/68
Nächste Seite
The SIM gives you three chances to enter the PIN
correctly. If the PIN is entered incorrectly three
times, the message ‘‘SIM BLOCKD’’ (SIM is
blocked) is displayed.
Should this happen, refer to the chapter Problems You Can
Solve.
After the PIN has been entered correctly, the phone
searches for a GSM network and the
message‘‘SEARCHING’’ is displayed.
Once a GSM network has been found, three short beeps are
heard and the SERV (Service) indicator comes on in the
display. An abbreviation for the GSM network is displayed
on the left of the display. You may now make and receive
calls.
A signal strength meter shows the strength of the
received signal, 0 to 5. A value of 5 indicates a strong signal
A battery meter is shown on the right of the display. It
starts at 5, after a fully charged battery has been attached
to the phone. As the battery loses charge, the battery meter
shows this in steps of 1, until 0 is shown when the battery
has no charge left. You can read more about this in the
chapter Batteries and Recharging.
Note the following points:
The phone will search for the ‘‘home’’ network. If this is not
available, the phone will search for a GSM network from
those in range, provided that Automatic Network
Selection is chosen.
If Manual Network Selection is chosen, and the ‘‘home’’
network is not available, ‘‘SEL NETW’’ (Select Network) is
displayed. Then you have to select a GSM network
yourself. You can read more about this in the description
of Special Function Nos. 7 and 9 in the chapter Special
Functions.
The SERV indicator flashes:
This indicates that a GSM network is in range, but the
phone will not register on that network. You can, however,
make emergency calls. Refer to the section Emergency
Calls, later in this chapter,
The message ‘‘NO NETW’’ (No Net-
work) is displayed:
No network is available.The reason may be:
You are in an area which is not covered by a network
The received signal is too weak.Try moving the phone or
the car to obtain a stronger signal. Refer to the chapter
Problems You Can Solve.
Network
Battery meter
Signal strength meter
Basic Operation
7
12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Ericsson GH198 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info