Bedienungsanleitung ESX DBX206Q (Seite 5 von 8) (Deutsch, Englisch)

700316

Zoom out

Zoom in

Vorherige Seite

1/8

Nächste Seite

ENGLISH

IMPORTANT NOTES

Choose a suitable location for your soundsystem, that neither the driver’s eld of vision nor the

security of the inmates will be affected. This stands also for airbag-zones and safety belts. The per-

manent temperature of the location should not be lower than 5°C and not higher than 50°C. Protect

the device from moisture and humidity.

Ensure that your subwoofer enclosure will not get loose during the drive and hurt someone in the

passenger cabin. It is recommended, that you mount the subwoofer enclosure with suitable belts or

any other mounting solutions in the trunk area.

Please observe not to damage any serial components of your vehicle (airbags, wires, gastank etc.)

during the installation of your soundsystem by drilling or any other operations.

Never screw or mount any other devices (amps, caps etc.) onto the subwoofer enclosure, this may

cause damage to the electricity.

For your personal concerns you should choose a appropriate sound level for the subwoofer enclo-

sure, that neither the roadworthy of the driver nor his concentration will be disturbed, that he is able

to notice possible trafc noises and acoustical warning signals.

Modern car audio soundsystems provide very high acoustic pressure beyond the 100 dB mark.

Please observe in this case, that permanent use of high sound levels may cause damage to your

ability of hearing.

Please ensure by any means the correct polarity of all connections. Faulty installed and connected

devices may get damage the vehicle and the device permanently.

Please check in any case the operation guide or wiring manual of your amplier which you’d like to

use for the soundsystem.

Never connect the speaker terminals with the 12 Volt power supply, otherwise the speakers may

get damaged.

POWER RATING

ESX subwoofer enclosures are designed for high bass levels. Anyhow it is possible, that unsatisfy-

ing sound characteristics could be caused by too low or too high amplier power. In certain circum-

stances this even can cause a damage to the loudspeakers.

It is recommended to choose rather a more powerful amplier (ca. 15-20% more Watts RMS than

the max. RMS power rating of the woofer) and to use the amplier not at the maximum output level

(low distortion factor, good sound characteristics). A weaker amplier at the maximum level causes

worse sound characteristics due to the higher distortion factor.

Never crank up the output volume of your amplier to the maximum level or run the amplier into

the clipping range. If the sound is distorted and not clean, turn back the level until the distortions

disappear.

ESX subwoofer enclosures have no integrated limiter or clipper, which is limiting the level upwards.

Overamplied bass peaks leads inevitably to a burn out of the voice coil of the woofer. A burn out of

the voice coil, caused by clipping/overamping is not covered by the usual warranty.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

ESX DBX206Q Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info