Bedienungsanleitung Etna 1755rvs (Seite 22 von 27) (Deutsch, Englisch, Holländisch, Französisch)

324077

Zoom out

Zoom in

Vorherige Seite

1/27

Nächste Seite

INSTALLATION

The appliance must be installed by qualified

staff working in accordance with the regula-

tions in force.

CONNECTING TO THE ELECTRICAL

MAINS

Before making the connection, check that:

- the mains voltage is as indicated on the

nameplate;

- the earth connection is in good working or-

der.

If the socket is not easily accessible, the in-

stallation engineer must provide a switch with

a contact breaking gap of 3 mm or more.

If the appliance power lead is not fitted with

a plug, use an approved standard type, re-

membering that:

- the green-yellow wire must be used for the

earth connection;

- the blue wire is the neutral;

- the brown wire is live;

- the lead must never touch hot surfaces over

about 75 degrees C;

- replacement leads must be of type H05RR-

F or H05V2V2-F of suitable size (see dia-

grams in fig. 2).

- if the appliance is supplied without lead,

using type H05RR-F or H05V2V2-F cable

of suitable size (see diagrams in fig. 2).

IMPORTANT: the manufacturer declines all

liability for damage due to failure to comply

with the regulations and standards in force.

Check that the appliance is correctly con-

nected to the earth (see diagrams in fig. 2 at

the back of the manual).

HOW TO USE THE COOKER

FOR COOKERS EQUIPPED WITH ELEC-

TRIC HOTPLATES

The different heat settings are obtained as

follows:

- 1 = minimum setting for all hotplates;

- 6 = maximum setting for normal and rapid

hotplates (with red disc);

- 0 = off.

Pans must never be smaller in diameter than

the hotplates and their bottoms must be as

flat as possible (see fig. 9).

IMPORTANT:

- Never leave hotplates on without pans,

except when first used; leave for about 10

minutes to dry oil or moisture residues;

- if the hotplate is to be out of use for a long time,

apply a little grease to its painted surface;

- do not allow spills to burn onto the hotplate,

requiring the use of abrasive cleaners.

HOW TO USE THE GAS OR ELECTRIC

GRILL

- fit the knob guard (see fig. 4);

- ignite the burner and wait a few minutes to

allow it to warm up, or switch on the heat-

ing element;

- place the foods on the chrome-plated shelf;

- insert on the highest runner;

- insert the drip tray on the bottom runner;

- gently close the oven door, resting it against

the knob guard;

- after a few minutes, turn the food to expose

the other side to the infrared radiation (the

cooking time depends on the type of food

and personal taste).

N.B.: the first time the grill is used smoke

will come out of the oven. Before inserting

foods for cooking, wait until any oil residues

on the burner have completely burnt away.

The grill must only be used at its full rated heat.

IMPORTANT: accessible parts may be hot

when the grill is in use! Keep children well

away.

The grill element in the top of the oven is

Installation

335101 55N ET PVC 28-04-2003, 16:1822

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Etna 1755rvs Seite 22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info