Bedienungsanleitung Etna A260A (Seite 27 von 34) (Deutsch, Englisch, Holländisch, Französisch)

482874

Zoom out

Zoom in

Vorherige Seite

1/34

Nächste Seite

RENSEIGNEMENTS DESTINES A LINSTALLATEUR

ROOMS VENTILATION

The cooker is fitted with 4 legs for an eventual alignment in height

with the furniture. To assemble them, it is necessary to raise the

cooker and to screw the four legs into the suitable threadings

placed on the corners on the bottom of the appliance ( fig 1).

INSTALLATION

IMPORTANT: The coating of the furniture must be able to withstand

high temperatures (min. 90°C).

If the appliance is to be installed near units, leave the minimum

gaps specified in the table below.

WARNINGS

The technical data are indicated on the data nameplate placed

on the rear of the appliance.

The adjustment conditions are stated on the label applied on the

packaging and on the appliance.

Do not use the oven door handle to move the appliance, such as

to remove it from the packaging.

The appliance is in class 1 or class 2 subclass 1.

VENTILATION OF ROOMS

Remember that this appliance can be installed and work in well-

ventilated rooms only, according to the standards in force, such

as to allow, with openings on the external walls or with special

ducts, a correct natural or forced ventilation ensuring permanently

and sufficiently both the entry of the air needed for correct

combustion and the removal of spent air.

In particular when there is only this gas appliance in the room,

there must be a hood over the appliance to ensure the natural

and direct removal of spent air, with a vertical straight duct of

length equal to at least twice the diameter and a minimum section

of at least 100 cm

For the indispensable entry of fresh air into the room there must

be a similar 100 cm

opening directly to the outside, situated at

a height near floor level so that it is not blocked either inside or

outside the wall and so as not to cause disturbances to correct

burners combustion and to the regular removal of spent air and

with a difference of height with respect to the outlet opening of at

least 180 cm.

Remember that the quantity of air necessary for combustion must

never be less than 2m

/h for each kW of power (see total power

in kW on the appliance data plate fig. A ).

In all other cases, i.e. when there are other gas appliances in the

same room, or when natural direct ventilation is not possible and

natural indirect or forced ventilation must be installed, contact a

qualified specialist who will install and make the ventilation system,

scrupulously observing the regulations contained in the standards

in force.

The openings must be so positioned that there are no draughts

of air which cannot be tolerated by the occupants.

Moreover to eliminate combustion products, it is forbidden to use

flues already used by other appliances.

min.100 mm

min. 50 mm

min. 650 mm

min. 400 mm

"0" mm "0" mm

min. 50 mm

min. 180 cm.

min. 100cm

min. 180 cm.

electrical fan

min. 100cm

.min. 100cm

. min. 100cm

Fig. 1

OK NO

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Etna A260A Seite 27

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info