Bedienungsanleitung Etna AFI8525ZT (Seite 33 von 88) (Deutsch, Englisch, Holländisch, Französisch)

446459

Zoom out

Zoom in

Vorherige Seite

1/88

Nächste Seite

3. Press the On/Off button. The dishwasher

must be in setting mode.

4. Press the programme selection/cancel

button until the light corresponding to the

required washing programme comes on

(see "Washing programmes" chart).

Close the dishwasher door, the pro-

gramme starts automatically.

Setting and starting the programme with

delay start

The start of the washing programme will

be delayed by 3 hours.

1. Select a washing programme.

2. Press the delay start button. The corre-

sponding indicator light comes on.

3. Close the dishwasher door. The count-

down starts automatically.

Opening the door will interrupt the

countdown. Once the door is closed the

countdown will continue from the point

at which it was interrupted.

4. Once the countdown has elapsed the

washing programme will start automati-

cally.

Cancel a delay start in progress

1. Open the dishwasher door.

2. Press the delay start button. The corre-

sponding indicator light goes off.

3. Close the dishwasher door. The washing

programme will start automatically.

Warning! Interrupt or cancel a

washing programme in progress

ONLY if it's absolutely necessary.

Attention! Hot steam may escape

when the door is opened. Open the

door carefully.

Interrupt a washing programme in

progress

Open the dishwasher door; the programme

will stop. Close the door; the programme will

start from the point at which it was interrup-

ted.

Cancel a washing programme in

progress

• Open the dishwasher door; press the pro-

gramme selection/cancel button for about

3 seconds, until the light of the running

programme goes off and the End indicator

light flashes. The washing programme has

been cancelled and the appliance is now

in setting mode. .

• If a new washing programme is to be se-

lected, check that there is detergent in the

detergent dispenser.

End of the washing programme

• The dishwasher will automatically stop and

an audible signal informs you of the end of

the washing programme.

• Open the dishwasher door.

•The End of programme indicator light is

on.

• The indicator light of the programme just

ended remains on.

1. Switch off the dishwasher by pressing the

On/Off button.

2. Leave the dishwasher door ajar and wait

a few minutes before removing the

dishes; in this way they will be cooler and

the drying will be improved.

Unloading the dishwasher

• Hot dishes are sensitive to knocks. The

dishes should therefore be allowed to cool

down before removing from the appliance.

•Empty the lower basket first and then the

upper one; this will avoid water dripping

from the upper basket onto the dishes in

the lower one.

• Water may appear on the sides and the

door of the dishwasher as the stainless

steel will eventually become cooler than

the dishes.

When the washing programme has

finished, it is recommended that the

dishwasher is unplugged and the

water tap turned off.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Etna AFI8525ZT Seite 33

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info