20
21 MAINTENANCE
MAINTENANCE
Changing the direction in which
the door opens
1. Remove the cover plates (1) and the
screws (2).
2. Remove the top cover (3) and the
decorative block (4).
3. Remove the screws (5) and the upper
hinge (6).
4. Carefully lift the door from the lower hinge
and place it on a padded surface to prevent
scratching.
5. Remove the plug (7) from the top of the
door and place it on the opposite side.
6. Remove the screws (8) and the lower
hinge (9).
7. Unscrew the adjustable foot (10) and place
it on the opposite side.
8. Fit the lower hinge (9) on the opposite side
with the screws (8).
9. Slide the door back on to the lower hinge,
making sure that the lower hinge pin ts
into the lower hole of the door.
10.Fit the upper hinge (6) on the opposite side
with the screws (5).
11.Place the decorative block (4) on the
opposite sidein the top cover (3).
12.Fit the top cover (3) with the screws (2).
Place the cover plates (1).
13.Check that door is aligned horizontally and
vertically and that the seals are closed on
all sides before nally tightening the
bottom hinge. Level the appliance with the
adjustable feet.
Changing the direction in which
the freezer compartment door
opens (if applicable)
1. Open the freezer compartment door a little.
Using a small screwdriver, press the spring
in the opening of the lower door bearing
and remove the door.
2. Position the covering cap M on the
opposite side.
3. Turn the freezer compartment door 180
degrees and t the lower door bearing into
the lower bearing cavity of the freezer
compartment door.
4. Fit the door in the upper door bearing and
at the same time insert the lower door
bearing into the square hole.
