461450
22
Zoom out
Zoom in
Vorherige Seite
1/31
Nächste Seite
WATER SOFTENER
Loading salt into the softener (The container must always be filled)
1.
Remove the lower basket and then unscrew and remove the cap from the
container.
2. If you are filling the container for the first time, fill
2
3 of its volume with
water.
3. Place the end of the funnel (supplied) into the hole and introduce about
1.2 kg of salt. It is normal for a small amount of water to come out of the
salt container.
ATTENTION: Remove spilt salt and start a washing program
immediately to prevent damage to the bottom of the diswasher.
4. Carefully screw the cap back on.
ATTENTION: The salt container must be refilled when the salt warning light in the control panel comes on.Though the salt
container is filled enough, the indicator light may not black out before the salt is fully dissolved.
Adjusting Salt Consumption
1. Within 60 seconds after switching on the diswasher: Press the start/reset button for 5 seconds.The rinse aid warning light and the
water softener warning light will flash alternatively.
2. Select the level of salt consumption by repeatedly pressing the program selector button. Each program corresponds with a certain
setting, see the table below.
* Factory setting
Contact your local water board for information on the hardness of your water supply.
This appliance is equipped with a water softener.
20
Always use salt intended for use with dishwasher. The salt container is located
beneath the rack and should be filled as follows:
You can adjust the amount of salt consumed based on the hardness of the water used.
Proceed as follows:
Water hardness
Water softener
setting
Number of light and sound signals
ºdH mmol/l
0 - 5 0 - 0,9 1 The intensive program indicator light is on and 1 signal sounds
6 - 11 1,0 - 2,0 2 The normal program indicator light is on and 2 signals sound
12 - 17 2,1 - 3,0 3* The ECO program indicator light is on and 3 signals sound
18 - 22 3,1 - 4,0 4 The glass program indicator light is on and 4 signals sound
23 - 34 4,1 - 6,1 5 The rapid program indicator light is on and 5 signals sound
35 - 45 6,2 - 8,0 6 The 3 in 1 program indicator light is on and 6 signals sound
700003352000 Hl_EVW7860_NL_GB.qxd 25-01-2010 14:57 Pagina 20
22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Etna EVW7860 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info