5 | 10
• 9 × screws to mount the bracket to the wall,
o Screws dimensions: 4.5x40 and 4.5x60 [mm],
• Cable gland rubber seal for smaller cable
dimensions
• *9 × wall spacers
• *2 × keys to open charging station service doors,
• *Hex key to open charging station maintenance doors,
o Hex key dimensions: 2.5
• *Load Guard device,
• *Magnetic cable holder (different version for longer
cables > 3 m)
EQUIPMENT NEEDE D
• Phillips screwdriver,
• *hex screwdriver,
• utility knife,
• crimping pliers for cable end sleeves,
• wire strippers and cable rippers.
*Optional depending on the purchased model.
INSTALLATION
PROCEDURE
The following descriptions are intended to be read
together with appropriate image at the beginning of the
document. The bold number at the left side of the
description represents the image number.
Wall Preparation
Measure and mark where to drill the holes for the wall
mounting bracket. Installation height of the wall
mounting bracket should be around 100 cm from the
ground to the bottom of the bracket. This will make the
procedure to insert the cable the easiest.
Make sure that the charging station holder is attached to
the mounting bracket when you are marking the spots
for screws. The holder will prevent any bending of the
